DIN EN 28736

Unhardened taper pins with internal thread (ISO 8736 : 1986) English version of DIN EN 28 736

English 1992

0.000

Detailed Information

This International Standard specifies the characteristics of unhardened taper pins with internal thread, and metric dimensions and nominal diameters, d1, from 6 to 50 mm inclusive.

Download File

(Log in to download spec.)

Check out other specifications

Others

IS 1367-2

2002

English

TECHNICAL SUPPLY CONDITIONS FOR THREADED STEEL FASTENERS PART 2 TOLERANCES FOR FASTENERS — BOLTS, SCREWS, STUDS AND NUTS — PRODUCT GRADES A, B AND C

This part of ISO 4759 specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A. The tolerances, except tolerances for threads, are selected from the system of limits and fits speci...

ASTM

ASTM A480/A480M

2008

English

Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip

1.1 This specification covers a group of general requirements that, unless otherwise specified in the purchase order or in an individual specification, shall apply to rolled steel plate, sheet, and strip, under each of the following specifications issued by ASTM: Specifications A 167, A 176, A 24...

SAE

SAE J123

1994

English

SURFACE DISCONTINUITIES ON BOLTS, SCREWS, AND STUDS IN FATIGUE APPLICATIONS

This SAE Recommended Practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur or become apparent during the manufacture and processing of bolts, screws, and studs which are primarily intended for use in automotive assemblies subject...

JIS

JIS B 1189

2005

English

Hexagon flange bolts

This Japanese Industrial Standard has been prepared based on ISO 15071 Hexagon bolts with flange—Small series—Product grade A and ISO 15072 Hexagon bolts with flange with metric fine pitch thread—Small series—Product grade A published in 1999 as the first edition by editing and integrating the co...

DIN

DIN 6883

1956

English

Taper Key Torque Transmission – Parallel Keys – Dimensions and Application

No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.

BS EN

BS EN 14399-6

2015

English

High-strength structural bolting assemblies for preloading Part 6: Plain chamfered washers

This European Standard specifies, together with EN 1 4399-1 and EN 1 4399-2, hardened and tempered chamfered plain washers with chamfer intended for bolting assemblies with large series hexagon high-strength structural bolts and nuts with thread sizes from M12 to M36 inclusive. Washers according...