This Standard specifies taper pipe threads and is applicable to the threads used mainly for pressure-tight joints on the threads for jointing the pipes, pipe fittings, fluid machinery, etc. The taper pipe thread of PT 3-1/ 2 and PT 7 to PT 12 in thread designation and the parallel pipe thread of...

Conical spring washers covered in this standard are deemed to be spring washers designed for use for bolt/nut assemblies involving bolts of property classes 8.8 to 10.9 as specified in ISO 898 Part 1. They are intended to counteract the effect of setting which results in bolt/nut assemblies worki...

(a) This standard covers general and dimensional data pertinent to the various types of screw and captive washer assemblies, otherwise known as SEMS. The word SEMS is recognized in the United States as a generic term applicable to screw and washer assemblies. Also included in this standard are a...

1.1.1 This standard covers complete general and dimensional data for those types of metric small solid rivets recognized as American Nalional Standard. Included is an appendix covering formulas on which dimensional data are based. It should be understood, however, that where questions arise conce...

The "with hexagon nut according to DIN 555" type is no longer contained in the representation of the cup head bolts. However, this type may still be ordered as part of this standard according to clause 2.

1.1 Dieser Teil von EN 10277 gilt für blanke, gerade Stäbe aus Automatenstählen Im gezogenen, geschälten oder geschliffenen Zustand. 1.2 Diese EN 10277-3 wird vervollständigt durch EN 10277-1.