Check out other specifications
1991
English
Cold rolled flat steel products for cold forming – Technical delivery conditions – English version of DIN EN 10130
This European Standard applies to cold rolled non-coated low carbon steel flat products in rolled widths equal to or over 600 mm for cold forming, with a minimum thickness of 0,35 mm, and unless otherwise agreed at the time of ordering, equal to or less than 3 mm, delivered in sheet, coil, slit c...
1998
English
ELECTRODEPOSITED COATINGS OF ZINC ON IRON AND STEEL
1.1 This specification covers requirements for electrodeposited zinc coatings applied to iron or steel articles to protect them from corrosion. It does not cover electrodeposited zinc coated steel wire or sheets (see ASTM A591/A591 M for sheets). 1.2 The coatings are provided in four standard thi...
1956
English
Taper Key Torque Transmission – Parallel Keys – Dimensions and Application
No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
1991
English
Quenched and tempered steels – Technical delivery conditions for special steels – English version of DIN EN 10083 Part 1
1.1 This European Standard gives the technical delivery requirements for — semi-finished products, hot formed, e.g. blooms, billets, slabs (see notes 3 and 4), — bars (see note 3), — rod, — wide flats, — hot or cold rolled sheet/plate and strip, — hammer and drop forgings (see note 3), manufact...
2011
English
Button head screws — Part 2: Hexagon socket button head screws with collar
This International Standard specifies the characteristics of hexagon socket button head screws with collar with threads from M3 up to and including M16, with product grade A and with reduced loadability according to Table 3. If, in special cases, specifications other than those listed in this In...