IFI-130

STRUCTURAL SPLITTING SELF-PLUGGING PULL MANDREL BLIND RIVETS

English 2008
0.000
IFI
Detailed Information

This standard establishes the dimensional, mechanical and performance requirements for structural splitting self-plugging pull mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.

Download File
(Log in to download spec.)

Check out other specifications

DIN EN
DIN EN 24014
1992
English

Hexagon head bolts – Product grades A and B (ISO 4014 : 1988) English version of DIN EN 24014

This International Standard gives specifications for hexagon head bolts with threads from M1,6 up to and including M64, of product grade A for threads M1,6 to M24 and nominal lengths up to and including 10 d or 150 mm, whichever is shorter and product grade B for threads over M24 or nominal lengt...
DIN
Beiblatt 1 zu DIN 267 Teil 2
1984
German

Mechanische Verbindungselemente – Technische Lieferbedingungen – Ausführung und Maßgenauigkeit – Beispiele für Toleranzangaben

In den nachfolgenden Bildtafeln sind - nach den Produktklassen A, B und C (bisher Ausführungen m, mg und g) geordnet - die aus DIN ISO 4759 Teil 1 und den bisherigen Festlegungen in DIN 267 Teil 2, Ausgabe April 1968, entnommenen Maßtoleranzen den verschiedenen DIN-Normen über Schrauben und Mutte...
ISO
ISO 965-3
1980
English

ISO general purpose metric screw threads – Tolerances – Part 3 : Deviations for constructional threads

This International Standard specifies deviations for pitch and crest diameters for ISO general purpose metric screw threads conforming to ISO 261, ISO general purpose metric screw threads - General plan. The deviations specified are derived from the fundamental deviations and tolerances specifie...
BS EN
BS EN 12163
2011
English

Copper and copper alloys — Rod for general purposes

This European Standard specifies the composition, property requirements and dimensional tolerances for copper alloy rod in the shape of circles, squares, hexagons or octagons, finally produced by drawing or extruding intended for general purposes. The sampling procedures and the methods of test ...
ASME
ASME B18.16.6
2008
English

NYLON INSERT LOCKNUTS (INCH SERIES)

This Standard covers the complete general, dimensional, mechanical, and performance data for carbon steel, inch series nylon insert locknuts of property grades NE2, NE5, and NE8 designated as American National Standard. The inclusion of dimensional data in this Standard is not intended to imply ...
Custom
Ford | WX100
2008
English

FINISH SPECIFICATION

The following specifications cover requirements for finishes used on Worldwide Standard and Utility Parts. NOTE: Obsolete finish specifications are not shown in this standard. If a finish is referenced that is not shown in this standard, the user should contact the local Fastener Engineering Offi...