Check out other specifications
1998
English
MECHANICAL AND QUALITY REQUIREMENTS FOR TAPPING SCREWS
1.1 This SAE Recommended Practice covers the mechanical and quality requirements for steel tapping screws used in automotive and related industries. It does not apply to corrosion resistant (stainless) steel screws. (Dimensional requirements for most types of screws mentioned herein are covered i...
1976
English
Securing Parts for Rolling Bearings – Snap Rings for Bearings with Ring Groove
For connection with DIN 616 and ISO 464, see Explanations. This Standard specifies the dimensions of snap rings required for securing bearing with ring groove according to DIN 616, diameter series 0, 2, 3 and 4.
2007
English
TORQUE-TENSION REQUIREMENTS FOR PREVAILING-TORQUE TYPE STEEL HEX AND HEX FLANGE NUTS
This standard covers torque-tension requirements for two types of plating: 0.0002/0.0004 in. thickness electrodeposited cadmium plated and lubricated Grades B and C prevailing-torque type steel hex nuts in sizes 1/4 to 1 in., inclusive, and Grades F and G prevailing-torque type steel hex flange n...
1986
English
Fasteners — General requirements for bolts, screws, studs and nuts
This International Standard specifies the general requirements for standardized bolts, screws, studs and nuts; it complements the International Standards on dimensional and tolerance requirements, and the International Standards on mechanical and functional requirements. It is recommended that t...
2000
English
Prevailing torque type steel hexagon nuts— Mechanical and performance properties
This Standard specifies the mechanical and performance properties for prevailing torque type steel hexagon nuts (including those with flange) when tested over an ambient temperature range of 10 °C to 35 °C. Properties will vary at higher and lower temperature.