ISO 5408

Cylindrical screw threads – Vocabulary

English French 1983

0.000

Detailed Information

This International Standard provides fundamental terms and definitions in English and French applicable to cylindrical screw threads with profiles (in an axial plane) based on triangles. A list of Russian equivalent terms is given in annex A.

Download File

(Log in to download spec.)

Check out other specifications

DIN EN

DIN EN 10130

1991

English

Cold rolled flat steel products for cold forming – Technical delivery conditions – English version of DIN EN 10130

This European Standard applies to cold rolled non-coated low carbon steel flat products in rolled widths equal to or over 600 mm for cold forming, with a minimum thickness of 0,35 mm, and unless otherwise agreed at the time of ordering, equal to or less than 3 mm, delivered in sheet, coil, slit c...

ASTM

ASTM A574

1998

English

Standard Specification for Alloy Steel Socket-Head Cap Screws

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required. NOTE 1-A complete metric companion to Specification A 574 has been developed-A 574M; therefore no metric equivalent...

ISO

ISO 965-1

1980

English

ISO general purpose metric screw threads – Tolerances – Part 1 : Principles and basic data

This International Standard specifies a tolerance system for screw threads conforming to ISO 261, ISO general purpose metric screw threads - General plan. The tolerance system refers to the basic profile according to ISO 68, ISO general purpose screw threads - Basic profile.

ASTM

ASTM F2280

2008

English

“TWIST OFF” TYPE TENSION CONTROL STRUCTURAL BOLT/NUT/WASHER ASSEMBLIES, STEEL, HEAT TREATED, 150 KSI MINUMUM TENSILE STRENGTH

1.1 This specification covers two types of heat treated, steel, tension control bolt-nut-washer assemblies, also referred to as "sets," having a tensile strength of 150 to 173 ksi. These assemblies are capable of developing a minimum predetermined tension when installed by applying torque to the ...

ASTM

Abstract of ASTM A325

2002

English

STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes over 1.0 to 1-1/2 in., inclusive. 1.2 The bolts are intended for use in structural connections. These co...

DIN EN

DIN EN 22340

1992

English

Clevis pins without head (ISO 2340 : 1986) English version of DIN EN 22 340

This International Standard specifies the characteristics of clevis pins without head, with metric dimensions and nominal diameters, d, from 3 to 100 mm inclusive.