Check out other specifications
1980
English
ISO general purpose metric screw threads – Tolerances – Part 3 : Deviations for constructional threads
This International Standard specifies deviations for pitch and crest diameters for ISO general purpose metric screw threads conforming to ISO 261, ISO general purpose metric screw threads - General plan. The deviations specified are derived from the fundamental deviations and tolerances specifie...
1968
English
Stressed-type Fastenings with Taper Action – Taper Keys with Gib Head – Keyways – Dimensions and Application
So far no permissible variations have been laid down for the taper on the key and in the keyway. If special conditions make necessary the observance of certain permissible variations these must be agreed at the time of ordering. The dimension h1 is the maximum height of the key (less gib head) an...
1986
English
Fasteners — General requirements for bolts, screws, studs and nuts
This International Standard specifies the general requirements for standardized bolts, screws, studs and nuts; it complements the International Standards on dimensional and tolerance requirements, and the International Standards on mechanical and functional requirements. It is recommended that t...
1975
English
Bright steel for key bars – Dimensions, limit deviations, mass
This Standard applies to bright key steel in bars of square, rectangular or flat-rectangular cross-section in the nominal dimensions indicated in Tables 1 and 2 and in the steel specified in Section 6. This Standard does not apply to bright flat steel (see DIN 174) and bright square steel (see D...