Check out other specifications
1995
English
Studs – with a length of engagement equal to about 1 d
This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in steel. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit thread’) or Sn4.
2009
English
Mechanical properties of fasteners made of carbon steel and alloy steel — Part 1: Bolts, screws and studs with specified property classes — Coarse thread and fine pitch thread
This part of ISO 898 specifies mechanical and physical properties of bolts, screws and studs made of carbon steel and alloy steel when tested at an ambient temperature range of 10 °C to 35 °C. Fasteners — the term used when bolts, screws and studs are considered all together — that conform to the...
2005
English
CLEVIS PINS AND COTTER PINS (INCH SERIES)
This standard covers the complete dimensional and general data for clevis pins recognized as "American National Standard."
1999
English
SCREW, MACHINE-DRILLED FILLISTER HEAD, SLOTTED, CORROSION RESISTING STEEL, PASSIVATED, UNC-2A
DRILLED HOLE IS TO BE APPROXIMATELY AT RIGHT ANGLES TO THE SLOT AND MAY BE PERMITTED TO BREAK THROUGH THE BOTTOM OF THE SLOT. ALL SHARP EDGES SHALL BE REMOVED.
2001
English
NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. inclusive in diameter manufactured from a number of alloys in common use and intended for general service applications. 1.2 Applicable nuts for use with bolts, cap ...
2008
English
STAINLESS STEEL SOCKET-SET SCREWS
1.1 This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS) sizes 0.060 through 0.500 in., in two conditions, AF and CW. 1.2 Units一The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in ...