Check out other specifications
1956
English
Taper Key Torque Transmission – Saddle Keys – Dimensions and Application
No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
2005
English
Fasteners — Non-electrolytically applied zinc flake coatings
This Standard specifies requirements for thickness, corrosion resistance and mechanical and physical properties of non-electrolytically applied zinc flake coatings on steel fasteners with metric threads. It applies to both coatings with or without chromate. Coatings according to this Standard m...
1972
English
Hexagon Head Tapping Screws
Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data. Technical conditions of delivery and material according to DIN 267 Sheet 12.
1997
English
Standard Specification for Stainless Steel Metric Bolts, Screws, and Studs
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric bolts, screws, and studs with nominal thread diameters M1.6 through M36, and intended for use in engineering applications requiring general corrosion resistance. 1.2 Eight groups of stainless steel a...
2007
English
TEST PROCEDURE FOR THE PERFORMANCE OF NONMETALLIC RESISTANT ELEMENT PREVAILING-TORQUE SCREWS
This standard establishes a conformance test procedure for the performance of Nonmetallic Resistant Element Prevailing-Torque Screws (hereinafter called "REPT screw"), in nominal screw sizes No. 0 thru 1-1/2 in. While the requirements of this standard apply to Nonmetallic Resistant Element Screws...
2001
English
ISO general purpose metric screw threads — Tolerances — Part 2: Limits of sizes for general purpose external and internal screw threads — Medium quality
This Standard specifies limits of sizes for pitch and crest diameters for ISO general purpose metric screw threads (M) conforming to JIS B 0205-3 having basic profile according to JIS B 0205-1. The limits of sizes for the tolerance quality specified are derived from the fundamental deviations an...
