JIS B 0212
Limits of sizes and tolerances for unified fine screw threads
English
1973
0.000
Detailed Information
This Japanese Industrial Standard specifies limits of sizes and tolerances for unified fine screw threads specified in JIS B 0208-Unified Fine Screw Threads, mainly used for the purpose of fastening.
Download File
(Log in to download spec.)
Check out other specifications
2007
English
TEST PROCEDURE FOR THE PERFORMANCE OF NUTS WITH PRE-APPLIED ADHESIVE COATED THREADS – INCH SERIES
This standard establishes a conformance test procedure for the performance of pre-applied adhesive coatings applied to inch series nuts, in nominal sizes 1/4 thru 1 inch intended for application temperatures of - 40°F to 350°F. Torque values for performance level I and level ll given in this sta...
1986
English
Knurled nuts
The following amendments have been made in comparison with the November 1970 edition. a) The content of the standard has been editorially revised and aligned with the basic standards concerned. b) The technical delivery conditions have been amended. c) The previous design m as specified in DIN 26...
2008
English
FINISH SPECIFICATION
The following specifications cover requirements for finishes used on Worldwide Standard and Utility Parts. NOTE: Obsolete finish specifications are not shown in this standard. If a finish is referenced that is not shown in this standard, the user should contact the local Fastener Engineering Offi...
1983
English
Hexagon flange bolts with reduced shank
This standard specifies product grade A hexagon flange bolts with metric coarse screw thread or metric fine screw thread from 5 up to and including 20 mm nominal thread diameter. If, in special cases, specifications other than those listed in this standard are required, e.g. different nominal len...
1997
English
Standard Specification for Stainless Steel Metric Bolts, Screws, and Studs
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric bolts, screws, and studs with nominal thread diameters M1.6 through M36, and intended for use in engineering applications requiring general corrosion resistance. 1.2 Eight groups of stainless steel a...
1991
English
Fasteners – Surface discontinuities – Bolts, screws and studs subject to general requirements (ISO 6157-1 : 1988) (English version of DIN EN 26 157 Part 1)
1.1 This part of ISO 6157 establishes limits for various types of surface discontinuities on bolts, screws and studs for general requirements. It applies to bolts, screws and studs with - nominal thread diameters 5 mm and larger; - product grades A and B; - property classes up to and including 1...