NASM 35650
NUT, PLAIN, HEXAGON, MACHINE SCREW, UNF-2B
English
2002
0.000
Detailed Information
MAGNETIC PERMEABILITY: CORROSION RESISTANT STEEL FASTENERS SHALL HAVE A MAGNETIC PERMEABILITY OF 2.00 MAXIMUM (AIR = 1.00) AT A FIELD STRENGTH OF H = 200 OERSTEDS USING A MAGNETIC INDICATOR IN ACCORDANCE WITH MIL-I-17214.
Download File
(Log in to download spec.)
Check out other specifications
2008
English
ROUND HEAD BOLTS (INCH SERIES)
1.1.1 This Standard covers the complete general and dimensional data for the various types of inch series bolts generally classified as round head bolts and recognized as American National Standard. 1.1.2 The inclusion of dimensional data in this Standard is not intended to imply that all of the...
2001
English
Fasteners—Electroplated coatings
This Standard specifies dimensional requirements for electroplated fasteners of steel or copper alloy. It specifies coating thicknesses and gives recommendations for hydrogen embrittlement relief for fasteners with high tensile strength or hardness and for surface-hardened fasteners. This Standa...
1992
English
Mechanical properties of fasteners – Part 7: Torsional test and minimum torques for bolts and screws with nominal diameters 1 mm to 10 mm
This part of ISO 898 specifies a torsional test for the determination of the breaking torque of bolts and screws with nominal diameters 1 mm to 10 mm with property classes 8.8 to 12.9 in accordance with ISO 898-1. The test applies to bolts and screws with thread less than M3 for which no breaking...
2001
English
ALUMINUM TRANSMISSION TOWER BOLTS AND NUTS
1.1 This specification covers aluminum structural bolts and nuts for use in the construction of aluminum transmission towers, substations, and similar aluminum structures. 1.2 Diameters of bolts and nuts furnished to this specification are 5/8, 3/4, and 7/8 in. 1.3 The values stated in inch-pound...
1978
English
Grooved Pins, Half Length Grooved with Gorge
Grooved pins according to this Standard are positive or non-positive connecting elements. They are used for holding retaining rings, retaining washers, springs, etc., the grooved pin being seated firmly in the accommodating hole, for which tolerance zone H11 is recommended.
1991
English
Break mandrel blind rivets
This standard specifies dimensions of, and requirements regarding material, design, strength and finish, as well as the relevant methods of test for, blind rivets of the self -plugging type. Such rivets consist of a rivet body and an integral mandrel, which breaks off on setting ('break mandrel',...