SAE J493
Rod Ends and Clevis Pins
English
1961
0.000
Detailed Information
The following publications form a part of the specification to the extend specified herein. Unless otherwise indicated the latest revision of SAE publications shall apply.
SAE J1010-Emission Control Hose
SAE J1111-Component Nomenclature-Skidder-Grapple
Download File
(Log in to download spec.)
Check out other specifications
2004
English
Hexagon head bolts and hexagon head screws
This Japanese Industrial Standard has been prepared based on the third edition of ISO 4014 : 1999 Hexagon head bolts—Product grades A and B published in 1999, the first edition of ISO 4015 : 1979 Hexagon head bolts—Product grade B—Reduced shank (shank diameter approximately equal to pitch diamete...
1970
English
Slotted Countersunk (Flat) Head Screws (Countersunk Heads according to ISO)
Intermediate length should as for as possible be avoided. Lengths over 100 mm should be arranged in 10 mm steps. Normally these screws are manufactured in the sizes characterized by the quoted weight. If the screws are to be supplied with captive washer components, an addition is made to the de...
1993
English
METRIC HEXAGON SOCKET HEAD SHOULDER SCREWS
1.1.1 This standard contains complete dimensional, mechanical, and performance requirements for Metric Series Hexagon Socket Head Shoulder Screws with nominal shoulder diameters from 6.5 mm to 25 mm recognized as American National Standard. Also included are appendices covering formulas for dimen...
1973
English
Knurls
Compared with the January 1940 issue of DIN 82, the standard denomination "knurl" has been adopted for all types, since the previous denomination "diamond knurling" and "negative diamond knurling" were not used consistently, and hence difficulties arose in the choice of tools. Some types of knurl...
2002
English
TECHNICAL SUPPLY CONDITIONS FOR THREADED STEEL FASTENERS PART 2 TOLERANCES FOR FASTENERS — BOLTS, SCREWS, STUDS AND NUTS — PRODUCT GRADES A, B AND C
This part of ISO 4759 specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A. The tolerances, except tolerances for threads, are selected from the system of limits and fits speci...
1988
English
Serrated lock washers
The main purpose of serrated lock washers is to permit the flow of electric current between components coated by varnish, anti-corrosive agents or similar materials, the bent ends of the washers piercing the coating when such components are joined. For such applications, the effectiveness of serr...