Abstract of ASTM B695

COATINGS OF ZINC MECHANICALLY DEPOSITED ON IRON AND STEEL

English 2000
0.000
ASTM
Detailed Information

1.1 This specification covers the requirements for a coating of zinc mechanically deposited on iron and steel basis metals. The coating is provided in several thicknesses up to and including 107 um (0.0042 in.). The seven thickest
classes are usually referred to as “mechanically galvanized.”

Download File
(Log in to download spec.)

Check out other specifications

DIN EN
DIN EN 24016
1992
English

Hexagon head bolts – Product grade C (ISO 4016 :1988) English version of DIN EN 24 016

This International Standard gives specifications for hexagon head bolts with threads from M5 up to and including M64 of product grade C. If, in special cases, specifications other than those l [...]
JIS
JIS B 0271
2004
English

Three wires for screw thread measuring and four wires for screw thread measuring

This Japanese Industrial Standard specifies three wires and four wire for screw thread measuring (hereafter referred to as “wires”) which consist of a set of three and four wires respectively, [...]
ISO
ISO 12683
2004
English

Mechanically deposited coatings of zinc — Specification and test methods

This document specifies the requirements for coatings of zinc that have been mechanically deposited on to fabricated metal articles to protect them from corrosion. It also describes the related [...]
ISO
ISO 3506-2
2009
English

Mechanical properties of corrosion-resistant stainless steel fasteners — Part 2: Nuts

This part of ISO 3506 specifies the mechanical properties of nuts made of austenitic, martensitic and ferritic steel grades of corrosion-resistant stainless steels, when tested over an ambient [...]
JIS
JIS B 1125
2003
English

Self drilling tapping screws

This Japanese Industrial Standard specifies self drilling tapping screws of steel made (hereafter referred to as “steel drilling tapping screws”) and those of martensitic stainless steel made ( [...]
ISO
ISO 7045
1994
English

Pan head screws with type H or type Z cross recess — Product grade A

This International Standard specifies the characteristics of pan head screws of product grade A, with threads from M1,6 to M 10 inclusive, and with type H or type Z cross recess.
ISO
ISO 6506-1
2014
English

Metallic materials — Brinell hardness test — Part 1: Test method

This part of ISO 6506 specifies the method for the Brinell hardness test for metallic materials. It is applicable to both fixed location and portable hardness testing machines. For some specif [...]
DIN
DIN 979
1987
English

Hexagon thin slotted nuts and castle nuts with metric coarse and fine pitch thread Product grades A and B

This standard specifies requirements for M6 to M52 hexagon slotted nuts and castle nuts, assigned to product grade A (up to size M16) or product grade B (for sizes above M16). If, in special c [...]
IFI
IFI-301
2008
English

GAGE CALIBRATION REQUIREMENTS AND PROCEDURES FOR THREAD GAGES

All UN, UNJ, M, and MJ thread form gages shall be calibrated using the commonly accepted metrology techniques described in this standard using properly maintained standard metrology equipment. [...]