Abstract of ASTM F467M

NONFERROUS NUTS FOR GENERAL USE

English 1993
0.000
ASTM
Detailed Information

1.1 This specification covers the requirements for commercial wrought nonferrous nuts in nominal thread diameters M6 to M36 inclusive in a number of alloys in common use and intended for general service applications.
1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this specification are covered by Specification ASTM F468M.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 557
1994
English

Product grade C square nuts

This standard specifies requirements for M 10 to M 12 square nuts assigned to product grade C. See DIN 962 (or the standards referred to therein) for special nut types or finishes. If, in s […]
DIN
DIN 928
2000
English

Square weld nuts

This standard specifies requirements for sizes M4 to M16 coarse and fine pitch thread square weld nuts of product grade A, for use with bolts of property classes below 8.8 as specified in D […]
ASME ANSI
ASME/ANSI B18.2.2
1999
English

SQUARE AND HEX NUTS (INCH SERIES)

1.1.1 This standard is intended to cover the complete general and dimensional data for the various types of inch series square and hex nuts recognized as "American National Standard." Also […]
ASTM
Abstract of ASTM F812/F812M
2002
English

SURFACE DISCONTINUITIES OF NUTS

1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of nuts with nominal diameters 1/4 […]
ASTM
Abstract of ASTM F1136
1998
English

CHROMIUM/ZINC CORROSION PROTECTIVE COATINGS FOR FASTENERS

1.1 This specification covers the basic requirements for three grades of chromium/zinc inorganic coatings for threaded fasteners. 1.2 These coatings are applied by conventional dip-spin or […]
DIN
DIN 5418
1993
English

Mounting dimensions of rolling bearings

This standard gives design details of shoulders of shafts and housings, in or on which rolling bearings are to be seated. Compliance with the values specified precludes distortion of the be […]
ASTM
ASTM A194/A194M
2010
English

Standard Specification for Carbon and Alloy Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both

1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1⁄4 through 4 in. and metric M6 through M100 nominal. It also covers austeni […]
JIS
JIS B 0002-2
1998
English

Technical drawings — Screw threads and threaded parts — Part 2 : Screw thread inserts

This part of JIS B 0002 specifies methods for the representation of screw thread inserts on technical drawings.
ISO
ISO 2903
1977
English

ISO metric trapezoidal screw threads – Tolerances

This International Standard specifies a tolerance system for metric trapezoidal screw threads according to ISO 2902. The tolerances refer to the basic profile according to ISO 2901. The to […]