Abstract of ASTM F468M

NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE [METRIC]

English 1993

0.000

Detailed Information

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications.
1.2 Unless otherwise specified, nuts used on these bolts, cap screws, and studs shall conform to the requirements of Specification ASTM F467M. Nuts shall be of the same alloy group as the fastener on which they are used, and shall have a specified minimum proof stress equal to or greater than the specified minimum tensile strength stress of the fastener on which they are used.

Download File

(Log in to download spec.)

Check out other specifications

JIS

JIS B 1099

2005

English

Fasteners — General requirements for bolts, screws, studs and nuts

This Standard specifies the general requirements for standardized bolts, screws, studs and nuts. It refers to the Standards on tolerances, mechanical and performance characteristics, geometrical features, surface discontinuities, surface finishes and quality aspects.

ISO

ISO 7042

2012

English

Prevailing torque type all-metal hexagon high nuts — Property classes 5, 8, 10 and 12

This International Standard specifies the characteristics of prevailing torque type all-metal hexagon high nuts, with threads from M5 up to and including M36, in product grade A for threads up to and including M16 and product grade B for threads above M16, and with property classes 5, 8, 10 and 12.

DIN

DIN 913

1980

English

Hexagon socket set screws with flat point – ISO 4026 modified

ISO 4026 specifies product grade A hexagon socket set screws with flat points with metric dimension and thread diameters from 1,6 up to and including 24 mm.

DIN

DIN 918 Supplement 3

2001

English

Overview of European Standards for fasteners

This Supplement reflects the most recent state of European standardization of fasteners by including: a) a list of DIN EN Standards classified by subject, and the correlated DIN Standards and DIN ISO Standards which have been withdrawn (table 1); b) numerical indexes of DIN EN Standards ( […]

JIS

JIS B 0253

1985

English

Gauges for taper pipe threads

This Japanese Industrial Standard specifies the taper thread gauge for pipe hereinafter referred to as the "thread gauge", to be used for the dimensional inspection of the taper external thread for pipe (R), taper internal thread for pipe (Rc) and parallel internal thread for pipe (Rp), w […]

DIN

DIN 601

1970

English

Hexagon Bolts without Hexagon Nut – with Hexagon Nut – Type g

This standard agrees essentially with the following ISO Recommendations issued by the International Organization for Standardization (ISO): ISO/R 272-1968 ISO/R 733-7968 ISO/R 855-1968 ISO/R 888-1968