Abstract of ASTM F593

STAINLESS STEEL BOLTS, HEX CAP SCREWS, AND STUDS

English 2002
0.000
ASTM
Detailed Information

1.1 This specification covers the requirements for stainless steel bolts, hex cap screws, and studs 0.25 to 1.50 in. nominal diameter inclusive in a number of alloys in common use and intended for service applications requiring general corrosion resistance.

Download File
(Log in to download spec.)

Check out other specifications

DIN EN
DIN EN 28674
1992
English

Hexagon nuts, style 2, with metric fine pitch thread – Product grades A and B (ISO 8674 :1988) English version of DIN EN 28 674

This International Standard gives specifications for hexagon nuts, style 2, with metric fine pitch thread, with nominal thread diameters d from 8 mm up to and including 36 mm, with product grade A for sizes d up to and including 16 mm and product grade B for sizes d over 16 mm.
DIN
DIN 6883
1956
English

Taper Key Torque Transmission – Parallel Keys – Dimensions and Application

No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
DIN
DIN 6325
1971
German

Zylinderstifte, gehärtet – Toleranzfeld m6

Zylinderstifte nach dieser Norm werden hauptsächlich als Poßstifte für Werkzeuge, Spannzeuge und Meßzeuge verwendet.
JIS
JIS B 0202
1999
English

Parallel pipe threads

This standard specifies parallel pipe threads and is applicable to the threads used mainly for mechanical connection to joint the pipes, pipe fittings, fluid machinery, etc. The parallel internal pipe thread of Class B of PF 1/8 to PF 6 in thread designation and the parallel thread of PF […]
ANSI
ANSI B18.22M
1990
English

METRIC PLAIN WASHERS

This standard covers general specifications and dimensions for flat, round hole washers, both soft (as fabricated) and hardened, intended for use in general purpose applications. The inclusion of dimensional data in this standard is not intended to imply that all sizes displayed are produ […]
ASTM
Abstract of ASTM A325
2002
English

STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes over 1.0 to 1-1/2 in., inclusive. 1.2 The bolts are intended for use in structural connections. […]