Abstract of ASTM F594

STAINLESS STEEL NUTS

English 2002
0.000
ASTM
Detailed Information

1.1 This specification covers the requirements for stainless steel nuts 0.25 to 1.50 in. in nominal diameter inclusive in a number of alloys in common use and intended for service applications requiring general corrosion resistance.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 925
1986
English

Slotted countersunk head screws with full dog point

The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN [...]
IFI
IFI-301
2008
English

GAGE CALIBRATION REQUIREMENTS AND PROCEDURES FOR THREAD GAGES

All UN, UNJ, M, and MJ thread form gages shall be calibrated using the commonly accepted metrology techniques described in this standard using properly maintained standard metrology equipment. [...]
DIN
DIN 50150
1976
English

Testing of Steel and Cast Steel – Conversion Table for Vickers Hardness, Brinell Hardness, Rockwell Hardness and Tensile Strength

The conversion table In this Standard applies - to hardness values determined according to the following standards: ~DIN 50 103 Part 1 and Part 2 (Rockwell) ~DIN 50 133 Part 1 (Vickers) and ~DI [...]
BS EN
BS EN 12163
2011
English

Copper and copper alloys — Rod for general purposes

This European Standard specifies the composition, property requirements and dimensional tolerances for copper alloy rod in the shape of circles, squares, hexagons or octagons, finally produced [...]
ASME
ABSTRACT OF ASME B1.3
2007
English

SCREW THREAD GAGING SYSTEMS FOR ACCEPTABILITY: INCH AND METRIC SCREW THREADS (UN, UNR, UNJ, M, AND MJ)

(a) This Standard presents screw thread gaging systems suitable for determining the acceptability of inch UN, UNR, and UNJ screw threads on externally and internally threaded products. It estab [...]
SAE
SAE J78
1998
English

Steel Self-Drilling Tapping Screws

1.1 General—This SAE Standard covers the dimensional and general specifications, including performance requirements, for carbon steel self-drilling tapping screws suitable for use in general ap [...]
2.01