Abstract of ASTM F836M

STAINLESS STEEL METRIC NUTS

English 1997
0.000
ASTM
Detailed Information

1.1 This specification covers the chemical and mechanical requirements for stainless steel metric nuts with nominal thread diameters M1.6 th rough M36, and intended for use in engineering applications requiring general corrosion resistance.
1.2 Eight groups of stainless steel alloys are covered, including three austenitic (Grades A1, A2, and A4), one ferritic (Grade F1), three martensitic (Grades Cl , C3, and C4), and one precipitation hardening (Grade P1).

Download File
(Log in to download spec.)

Check out other specifications

ASTM
ASTM A687
1993
English

Standard Specification for High-Strength Nonheaded Steel Bolts and Studs

1.1 This specification covers the chemical and mechanical requirements for quenched and tempered steel nonheaded bolts and studs with enhanced Charpy V-notch impact properties for anchorage […]
ASME ANSI
ASME/ANSI B18.3.4M
1993
English

METRIC HEXAGON SOCKET BUTTON HEAD CAP SCREWS

1.1.1 This standard contains the complete general and dimensional requirements for metric series hexagon socket button head cap screws of nominal sizes from 3 mm to 16 mm recognized as an A […]
NASM
NASM 24671
1998
English

SCREW, CAP, SOCKET HEAD, FLAT COUNTERSUNK, 82°, CORROSION-RESISTING STEEL, UNC-3A

MATERIAL: STEEL CORROSION-RESISTING, IN ACCORDANCE WITH FED. STD No 66; AISI 302. 303. 304, 305. 316 OR 384 (DEVELOPED FOR COLD HEADING). MINIMUM ULTIMATE TENSILE STRENGTH SHALL BE 80.000 P […]
ASTM
ASTM F879M
1991
English

Standard Specification for Stainless Steel Socket Button and Flat Countersunk Head Cap Screws [Metric]

1.1 This specification covers the chemical and mechanical requirements for stainless steel metric hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws with nominal thr […]
ASME ANSI
ASME/ANSI B18.3.1M
1993
English

METRIC SOCKET HEAD CAP SCREWS

1.1.1 This standard contains complete general and dimensional data for metric series hexagon socket head cap screws in sizes from 1.6 mm to 48 mm and for metric series spline socket head ca […]
DIN EN
DIN EN 20898-2
1994
English

Mechanical properties of fasteners – Nuts with coarse pitch thread and specified proof load values (ISO 898-2 : 1992) English version of DIN EN 20898 Part 2

This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lowe […]
ASTM
ASTM B841
1999
English

Standard Specification for Electrodeposited Coatings of Zinc Nickel Alloy Deposits

1.1 This specification covers the requirements for electrodeposited zinc nickel alloy coatings on metals.
ISO
ISO 2768-1
1989
English

General tolerances — Part 1 : Tolerances for linear and angular dimensions without individual tolerance indications

This part of ISO 2768 is intended to simplify drawing indications and it specifies general tolerances for linear and angular dimensions without individual tolerance indications in four tole […]
ASTM
Abstract of ASTM F1136
1993
English

CHROMIUM/ZINC CORROSION PROTECTIVE COATINGS FOR FASTENERS

1.1 This specification covers the basic requirements for three grades of chromium/zinc inorganic coatings for threaded fasteners. 1.2 These coatings are applied by conventional dip-spin or […]