ASME B18.16.4
SERRATED HEX FLANGE LOCKNUTS 90,000 psi (INCH SERIES)
English
2008
0.000
Detailed Information
This Standard covers the general, dimensional, and mechanical performance requirements for low strength carbon steel, case hardened, regular and large serrated flange locknuts (inch series), recognized as American National Standard.
Download File
(Log in to download spec.)
Check out other specifications
1999
English
CLEARANCE HOLES FOR BOLTS, SCREWS, AND STUDS
This standard covers the recommended clearance hole sizes for #0 through 1.5 inch fasteners in three classes of clearance using a close-, normal-, and loose-fit category.
1990
English
General rules for tightening of threaded fasteners
This Japanese Industrial Standard specifies general matters relating to significance of tightening by combination of bolt and nut, basis of tightening and representative control method. Furthe [...]
1991
English
Standard Specification for Stainless Steel Socket Head Cap Screws [Metric]
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric socket head cap screws (SHCS) with nominal thread M 1.6 through M 36 and intended for use in ap [...]
1995
English
METRIC FORMED HEX SCREWS
1.1 This standard covers the complete general and dimensional data for metric formed hex screws recognized as American National Standard. Formed hex screws are cold formed products with fully u [...]
2008
English
SERRATED HEX FLANGE LOCKNUTS 90,000 psi (INCH SERIES)
This Standard covers the general, dimensional, and mechanical performance requirements for low strength carbon steel, case hardened, regular and large serrated flange locknuts (inch series), re [...]