Check out other specifications
1998
English
SQUARE AND HEX MACHINE SCREW NUTS
1. ANSI/ASME B18.6.3 is a standard developed through the procedures of The American Society of Mechanical Engineers. B18.6.3 is under the jurisdiction of ASME Standards Committee B18 and is the direct responsibility of its Subcommittee 6. 2. B18.6.3 covers machine screws and machine screw […]
1992
English
Unhardened taper pins (ISO 2339 : 1986) English version of DIN EN 22 339
This International Standard specifies the characteristics of unhardened taper pins, with metric dimensions and nominal diameters, d, from 0,6 to 50 mm inclusive.
1993
English
Standard Specification for Steel Transmission Tower Bolts, Zinc-Coated and Bare
1.1 This specification covers the chemical and mechanical requirements of hexagon and square-head zinc-coated steel bolts and atmospheric corrosion-resistant bolts, in nominal thread diameters of 1/2, 5/8, 3/4, and 1 in. for use in the construction of transmission towers, substations. and […]
1983
English
Countersunk head screws – Head configuration and gauging
This International Standard specifies the Characteristics of head configurations of slotted and recessed countersunk head screws, and recommends a gauging method for the head dimensions laid down in the respective product standards.
1992
English
Hexagon head pipe plugs
This standard specifies dimensions and technical delivery conditions for pipe plugs which are intended to be screwed Into holes with parallel thread as specified in DIN 13 Part 12, DIN 158, DIN 3858 or ISO 228 Part 1. Since tightness is a function of pressure, temperature, the materials i […]
2015
English
High-strength structural bolting assemblies for preloading Part 1: General requirements
This European Standard specifies the general requirements for bolt/nut/washer(s) assemblies for high-strength structural bolting, which are suitable for preloading. The intended use of bolting assemblies in accordance with this European Standard is structural metallic works. NOTE 1 High […]