ASME B18.9

PLOW BOLTS (INCH SERIES)

English 1996
0.000
ASME
Detailed Information

1.2.1 This standard recommends Table 1, No. 3 square neck, 80 deg round countersunk head and Table 2, No. 7 reverse key, 60 deg round countersunk head plow bolts for new designs. It includes No. 3 square neck, round countersunk repair head; Table 3, No. 4 countersunk, square repair head; Table 4, No. 6 heavy key, round countersunk repair head; and No. 7 reverse key, round countersunk repair head plow bolts for service purposes.

1.2.2 Dimensions of Table 3, No. 4 countersunk square regular head and Table 4, No. 6 heavy key, round countersunk regular head plow bolts are given in Appendix A, as supplementary information, but not forming a part of this standard.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 887
1983
English

Plain washers for metric bolts, screws and nuts – General plan

This International Standard lays down the specification for the full range of plain washers of product grades A and C for bolts, screws and nuts with thread sizes from M 1 to M 150 inclusive. This International Standard does not apply to washers for preassembled bolts and screws as far a […]
ISO
ISO 1479
1983
English

Hexagon head tapping screws

This International Standard specifies the characteristics of hexagon head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.
DIN
DIN 267-18
1981
German

Mechanische Verbindungselemente – Technische Lieferbedingungen – Teile aus Nichteisenmetallen

Diese Norm gilt für mechanische Verbindungselemente mit Gewinde (im wesentlichen Schrauben und Muttern) als Fertigteile aus Nichteisenmetallen (Schwermetalle und Leichtmetalle) mit - metrischem ISO-Gewinde nach DIN 13, - Blechschraubengewinde nach DIN 7970, - Holzschraubengewinde nach DIN […]
DIN EN
DIN EN 10277-3
1999
German

Blankstahlerzeugnisse – Technische Lieferbedingungen Teil 3: Automatenstähle – Deutsche Fassung EN 10277-3 : 1999

1.1 Dieser Teil von EN 10277 gilt für blanke, gerade Stäbe aus Automatenstählen Im gezogenen, geschälten oder geschliffenen Zustand. 1.2 Diese EN 10277-3 wird vervollständigt durch EN 10277-1.
DIN
DIN 6912
1985
English

Hexagon socket thin head cap screws with pilot recess for wrench key

This standard specifies product grade A hexagon socket thin head cap screws with pilot recess for wrench key with ISO metric screw thread from M4 up to and including M36. If, in special cases, the screws are to meet requirements other than those given in this standard, e.g.with regard to […]
ANSI ASME
Abstract of ANSI/ASME B1.7M
2001
English

NOMENCLATURE, DEFINITIONS, AND LETTER SYMBOLS FOR SCREW THREADS

1. ANSI/ASME B1.7M is a standard developed through the procedures of The American Society of Mechanical Engineers. B1.7M is under the jurisdiction of ASME Standards Committee B1. 2. B1.7M establishes uniform practices for standard screw threads with regard to screw thread nomenclature and […]