ASTM F468M

Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use [Metric]

English 1997
0.000
ASTM
Detailed Information

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws. and studs in
nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications.
1.2 Unless otherwise specified, nuts used on these bolts, cap screws, and studs shall conform to the requirements of Specification F 467M. Nuts shall be of the same alloy group as the fastener on which they are used, and shall have a specified minimum proof stress equal to or greater than the specified minimum tensile strength stress of the fastener on which they are used.

Download File
(Log in to download spec.)

Check out other specifications

DIN EN
DIN EN 28752
1993
English

Slotted spring-type straight pins (ISO 8752: 1987) English version of DIN EN 28 752

This International Standard specifies the characteristics of slotted spring-type straight pins with metric dimensions and nominal diameters, d1, from 1 to 50 mm Inclusive.
ASTM
Abstract of ASTM F1135
1999
English

CADMIUM OR ZINC CHROMATE ORGANIC CORROSION PROTECTIVE COATINGS FOR FASTENERS

1.1 This specification covers the basic performance requirements for an electrolytic or mechanical coating of cadmium or zinc followed by a chromate and baked organic coating for ferrous an […]
JIS
JIS B 1045
2001
English

Fasteners—Preloading test for the detection of hydrogen embrittlement — Parallel bearing surface method

This Standard specifies a preloading test which is able to detect the occurrence of hydrogen embrittlement of fasteners at room temperature. This test is applicable to — metric bolts, scre […]
DIN EN
DIN EN 28746
1992
English

Grooved pins with round head (ISO 8746 : 1986) English version of DIN EN 28 746

This International Standard specifies the characteristics of round head grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric […]
DIN
DIN 1448-1
1970
English

Conical Shaft Ends – with External Thread – Dimensions

For connection with ISO Recommendation ISO/R 775-1969, see Explanations. Conical shaft ends are intended to take belt pulleys, couplings and gears. Sizes and details such as chamfer, cent […]
Custom
Ford | WX100
2008
English

FINISH SPECIFICATION

The following specifications cover requirements for finishes used on Worldwide Standard and Utility Parts. NOTE: Obsolete finish specifications are not shown in this standard. If a finish i […]
ASTM
ASTM B16 B16M
2005
English

Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines

1.1 This specification establishes the requirements for free-cutting brass rod, bar, wire, and shapes of any specified cross section produced from Copper Alloy UNS No. C36000 suitable for h […]
ISO
ISO 1482
1983
English

Slotted countersunk (flat) head tapping screws (common head style)

This International Standard specifies the characteristics of slotted countersunk (flat) head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.
ANSI
ANSI B18.2.4.5M
1990
English

METRIC HEX JAM NUTS

1.1 This standard covers the complete general and dimensional data for metric hex jam nuts recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard i […]