BS EN 20898-2

Mechanical properties of fasteners – Part 2: Nuts with specified proof load values – Coarse thread

English 1994

0.000

Detailed Information

This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lower temperature.

Download File

(Log in to download spec.)

Check out other specifications

NASM

NASM 3213

1998

English

SCREWS, MACHINE, PAN HEAD, CROSS-RECESSED, SELF-SEALING, INTEGRAL FLUOROSILICONE O-RING, PLAIN AND SELF-LOCKING

(a) SCREW: CORROSION-RESISTING STEEL (CRES) IN ACCORDANCE WITH MIL-S-82496. (b) 0-RING: FLUOROSILICONE RUBBER, COMPOSITION B IN ACCORDANCE WITH MIL-S-82496 (RESISTANT TO MIL-H-5606 HYDRAULIC FLUID AND TYPE III FUEL OF TT-S-735).

DIN

DIN 967

1994

English

Product grade A cross recessed pan head screws with collar

This standard specifies requirements for M 3 to M 8 cross recessed pan head screws assigned to product grade A. See DIN 962 (or the standards referred to therein) for special screw types or finishes. If, in special cases, screws are to comply with specifications other than those given in […]

DIN EN

DIN EN 28750

1992

English

Coiled, standard duty spring-type straight pins (ISO 8750 : 1987) English version of DIN EN 28 750

This International Standard specifies the characteristics of standard duty coiled spring-type straight pins with metric dimensions and nominal diameters, d1, from 0,8 to 20 mm inclusive.

ASTM

Abstract of ASTM F835M

1992

English

ALLOY STEEL SOCKET BUTTON AND FLAT COUNTERSUNK HEAD CAP SCREWS [METRIC]

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws M3 through M20 thread sizes having material properties of ISO 898/1 Property Class 12.9. 1.2 Fasteners meeting this specification […]

DIN EN

DIN EN 28738

1992

English

Plain washers for use with clevis pins, product grade A (ISO 8738 : 1986) English version of DIN EN 28 738

This International Standard specifies the characteristics of plain washers for clevis pins according to ISO 2340 and ISO 2341. Plain washers in accordance with this International Standard shall be used on the cotter pin end only.

ASME

ASME Draft Revision B18.6.7M

1998

English

METRIC MACHINE SCREWS

This standard covers the complete general and dimensional data for metric flat countersunk, oval countersunk and pan slotted and recessed head machine screws and metric hex and hex flange head machine screws recognized as standard. Also included are Appendices which provide specifications […]