Check out other specifications
1983
German
Mechanische Verbindungselemente – Technische Lieferbedingungen – Festigkeitsklassen für Muttern mit Feingewinde (ISO-Klassen)
Im Jahre 1967 wurde die Norm DIN 267 Teil 4 auf internationale Festigkeitsklassen für Muttern umgestellt. Die alten Kennzeichen 4D, 5D, 5S, 6G, 6S und 8G wurden durch die Kennzahlen 4, 5, 6, 8, 10, 12 und 14 ersetzt, wobei die Kennzahl 1/100 der Mindestzugfestigkeit (N/mm2) der Schraube e […]
1986
English
Slotted raised countersunk head screws with full dog point
The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN 267 Part 2, April1968 edition, has been replaced by product grade F as specified in DIN 267 Par […]
2001
English
Overview of European Standards for fasteners
This Supplement reflects the most recent state of European standardization of fasteners by including: a) a list of DIN EN Standards classified by subject, and the correlated DIN Standards and DIN ISO Standards which have been withdrawn (table 1); b) numerical indexes of DIN EN Standards ( […]
1990
English
Large size washers
This standard specifies requirements for product grades A and C washers with a large outside diameter, i.e. washers with an outside diameter approximately equal to three times the nominal thread diameter of bolts with which the washers are intended to be used. The preferred application of […]
2004
English
ALLOY STEEL SOCKET SET SCREWS
1.1 This specification covers the requirements for quenched and tempered alloy steel socket-set screws (SSS) 0.060 through 2.000-in. sizes having hardnesses 45 to 53 HRC. 1.2 These set screws are intended for compression applications only and are not customarily subjected to embrittlemen […]