Check out other specifications
2005
English
Fasteners — Non-electrolytically applied zinc flake coatings
This Standard specifies requirements for thickness, corrosion resistance and mechanical and physical properties of non-electrolytically applied zinc flake coatings on steel fasteners with metri [...]
2004
English
Hot rolled products of structural steels — Part 1: General technical delivery conditions
1.1 This document specifies requirements for flat and long products (see Clause 3) of hot rolled structural steels excluding structural hollow sections and tubes. Part 1 of this document specif [...]
2015
English
High-strength structural bolting assemblies for preloading Part 6: Plain chamfered washers
This European Standard specifies, together with EN 1 4399-1 and EN 1 4399-2, hardened and tempered chamfered plain washers with chamfer intended for bolting assemblies with large series hexagon [...]
2001
English
ISO general purpose metric screw threads — Tolerances — Part 4: Limits of sizes for hot -dip galvanized external screw threads to mate with internal screw threads tapped with tolerance position H or G after galvanizing
This Standard specifies deviations and limits of sizes for pitch and crest diameters for ISO general purpose metric external screw threads conforming to JIS B 0205-3 having a basic profile acco [...]
1992
English
Hardened parallel pins with internal thread (ISO 8735 : 1987) English version of DIN EN 28 735
This International Standard specifies the characteristics of through hardened and case hardened parallel pins with internal thread, metric dimensions and nominal diameters, d1, from 6 to 50 mm [...]
1992
English
Full-length taper grooved pins (ISO 8744 : 1986) English version of DIN EN 28 744
This international Standard specifies the characteristics of full-length taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metr [...]
1982
English
Disc wheels for motor vehicles and trailers – Fasteners for stud centring
This standard specifies requirements for fasteners for stud-centred disc wheels on motor vehicles and trailers. Any necessary draft on the hexagon shall be within the tolerance on the width acr [...]