This standard covers the complete general and dimensional data for eight product types of inch series square and hex bolts and screws recognized as American National Standard. Also included are appendixes covering thread runout sleeve gages, gaging procedure for checking bolt and screw st […]

1.1 Scope. This standard describes procedures for the mechanical testing of inch series blind rivets to determine properties required in the product standard. 1.2 The following tests are described: Shear strength, Para. 2.1 Tensile strength, Para. 2.2 Mandrel break load, Para. 2.3 Blind h […]

1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications. 1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this s […]

This Japanese Industrial Standard specifies steel-made T-slot bolts (hereafter, referred to as "bolts") to be used mating with T slots (JIS B 0952). The strength class 6T of mechanical properties specified in this Standard will be withdrawn on April 1, 1999.

Üblicherweise werden diese Schrauben in den durch Gewichtsangabe gekennzeichneten Größen hergestellt. Technische Lieferbedingungen nach DIN 267

This International Standard specifies the characteristics of hexagon head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.