Check out other specifications
2008
English
PULL THROUGH MANDREL BLIND RIVETS
This standard establishes the dimensional, mechanical, and performance requirements for inch series pull through mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement. A metric series counterpart standard is […]
1992
English
Hexagon nuts, style 2, with metric fine pitch thread – Product grades A and B (ISO 8674 :1988) English version of DIN EN 28 674
This International Standard gives specifications for hexagon nuts, style 2, with metric fine pitch thread, with nominal thread diameters d from 8 mm up to and including 36 mm, with product grade A for sizes d up to and including 16 mm and product grade B for sizes d over 16 mm.
1990
English
Screw and washer assemblies – Coarse threaded screws with captive serrated lock washer
This standard specifies requirements for screw and washer assemblies consisting of a M2,5 to M10 screw with flat bearing face, assigned to a property class below 5.8, and a captive serrated lock washer. Serrated lock washers are mainly designed to provide electric contact between componen […]
1993
English
HIGH-STRENGTH BOLTS FOR STRUCTURAL STEEL JOINTS [METRIC]
1.1 This specification covers requirements of various types of quenched and tempered steel bolts in nominal thread diameters M16 to M36 inclusive, commonly known as "high-strength structural bolts," intended for use in structural joints that are comparable to those made under the Specific […]
2011
English
Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules
This International Standard specifies fundamental concepts, principles and rules valid for the creation, interpretation and application of all other International Standards, Technical Specifications and Technical Reports concerning dimensional and geometrical product specifications (GPS) […]