DIN 1804

Slotted Round Nut for Hook Spanner – ISO Metric Fine Thread

English 1971
0.000
DIN
Detailed Information

Material (strength properties): at least 5 according to DIN 267 Sheet 4
Type: w unhardened and unground
h hardened to HRC 60 ± 2 with the exception of the thread, faces ground
For hook wrenches, see DIN 1810

Download File
(Log in to download spec.)

Check out other specifications

ASME
ASME B18.5.2.3M
1998
English

ROUND HEAD SQUARE NECK BOLTS WITH LARGE HEAD [METRIC SERIES]

This standard covers the complete general and dimensional data for metric series round head square neck bolts with large head recognized as American National Standard.
DIN
DIN 6881
1956
English

Taper Key Torque Transmission – Saddle Keys – Dimensions and Application

No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
ISO
ISO 3506-1
2009
English

Mechanical properties of corrosion-resistant stainless steel fasteners — Part 1: Bolts, screws and studs

This part of ISO 3506 specifies the mechanical properties of bolts, screws and studs made of austenitic, martensitic and ferritic steel grades of corrosion-resistant stainless steels, when tested over an ambient temperature range of 10 °C to 35 °C. Properties vary at higher or lower tempe […]
DIN
DIN 607
1981
English

Cup head nib bolts

The "with hexagon nut according to DIN 555" type is no longer contained in the representation of the cup head bolts. However, this type may still be ordered as part of this standard according to clause 2.
IFI
IFI-123
2008
English

DRIVE PIN BLIND RIVETS

This standard establishes the requirements for drive pin blind rivets suitable for use in joining the component parts of an assembly.
DIN EN
DIN EN 28744
1992
English

Full-length taper grooved pins (ISO 8744 : 1986) English version of DIN EN 28 744

This international Standard specifies the characteristics of full-length taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, d1, from 1,5 to 25 mm inclusive. The displaced material to […]