DIN 1816

Round Nut with Set Pin Holes Inside – ISO Metric Fine Thread

English 1971
0.000
DIN
Detailed Information

Material (strength properties): at least 5 according to DIN 267 Part 4

Download File
(Log in to download spec.)

Check out other specifications

ASTM
ASTM F467
2008
English

NONFERROUS NUTS FOR GENERAL USE

1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general servi [...]
ISO
ISO/R 2101
1971
English

ALUMINIUM AND ALUMINIUM ALLOYS – SHEAR TEST FOR RIVET WIRE AND RIVETS

This ISO Recommendation applies to the shear testing of aluminium and aluminium alloy rivet wire and rivets, having a diameter not greater than 10 mm (3/8 in).
DIN
DIN 7990
1989
English

Hexagon head bolts for structural steel bolting for supply with nut

This standard specifies requirements for M12 to M30 hexagon head bolts for supply with hexagon nut, assigned to product grade C, for use in structural steel bolting. These bolts shall always be [...]
ISO
ISO 4757
1983
English

Cross recesses for screws

This International Standard defines two types of cross recesses for screws: - recess type H; - recess type Z. Included in this International Standard is a method of penetration gauging for both types.
ASME ANSI
ASME/ANSI B18.3.3M
1993
English

METRIC HEXAGON SOCKET HEAD SHOULDER SCREWS

1.1.1 This standard contains complete dimensional, mechanical, and performance requirements for Metric Series Hexagon Socket Head Shoulder Screws with nominal shoulder diameters from 6.5 mm to [...]
ISO
ISO 3269
2000
English

Fasteners — Acceptance inspection

1.1 This International Standard specifies the acceptance inspection procedure that the purchaser of fasteners must follow in order to determine whether a lot of fasteners will be accepted or re [...]
DIN
DIN 258
1977
English

Taper Pins with Thread Ends and Constant Taper Lengths

As part of the work of Technical Committee ISO/TC 2, ISO standards for parallel pins and taper pins have been drawn up which necessitated a general revision of existing DIN standards. In that p [...]
DIN
DIN 927
1986
English

Slotted shoulder screws

The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN [...]
DIN
DIN 960
1970
German

Sechskantschrauben – Metrisches Feingewinde – Ausführung m und mg

Eingeklammerte Größen sind möglichst zu vermeiden. Üblicherweise werden diese Schrauben in den durch Gewichtsangabe gekennzeichneten Größen hergestellt. Technische Lieferbedingungen noch DIN 267