Check out other specifications
1995
English
Standard Specification for Steel Rivets and Bars for Rivets, Pressure Vessels
1.1 This specification covers steel rivets for use in boilers and pressure vessels and steel bars for use in the manufacture of rivets. 1.2 Two grades are covered: 1.2.1 Grade A-Bars having a yield point of 23 000 psi (160 MPa) minimum with no controls on carbon content. 1.2.2 Grade B-Ba […]
1995
English
METRIC HEAVY HEX STRUCTURAL BOLTS
1.1 This standard covers the complete general and dimensional data for metric heavy hex structural bolts recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is not intended to imply that all of the sizes in conjunction with the various options […]
1996
English
METRIC THREAD ROLLING SCREWS
This SAE standard covers requirements for metric thread rolling screws suitable for use in general engineering applications. Requirements for three material-process options are stated: a. Screws (in sizes M2 x 0.4 thru M12 x 1.75) manufactured from low carbon steel, carburized, and temp […]
2008
English
“TWIST OFF” TYPE TENSION CONTROL STRUCTURAL BOLT/NUT/WASHER ASSEMBLIES, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH
1.1 This specification covers two types of heat treated, steel, tension control bolt-nut-washer assemblies, also referred to as “sets." These assemblies are capable of developing a minimum predetermined tension when installed by applying torque to the nut, while at the same time applying […]
1995
English
Machine screws and nuts for spectacle frames
This Japanese Industrial Standard specifies the machine screws made of stainless steel, brass, and nickel silver (hereafter referred to as “machine screws”) as well as the nuts made of nickel silver.
1992
English
Mechanical properties of fasteners – Bolts, screws and studs (ISO 898-1 : 1988) English version of DIN EN 20 898 Part 1
This part of ISO 898 specifies the mechanical properties of bolts, screws and studs when tested at room temperature (see ISO 1) . Properties will vary at higher and lower temperature.
5.01