DIN 315

Wing nuts

English 1983
0.000
DIN
Detailed Information

The following amendments have been made in comparison with the December 1972 edition:
a) The dimensions of the wing nuts have been altered in some respects.
b) Limiting sizes have been adopted.
c) Sizes M 2 to M 3,5 have been deleted.
d) The technical delivery conditions have been complemented.
e) The contents of the standard have been revised editorially.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM F835M
1992
English

ALLOY STEEL SOCKET BUTTON AND FLAT COUNTERSUNK HEAD CAP SCREWS [METRIC]

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws M3 through M20 thread sizes havin [...]
ISO
ISO 1481
1983
English

Slotted pan head tapping screws

This International Standard specifies the characteristics of slotted pan head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.
ISO
ISO 1478
1983
English

Tapping screws thread

This International Standard specifies the thread and thread ends for tapping screws (sheet metal screws) with thread sizes from ST 1,5 to ST 9,5 inclusive.
NASM
NASM 21266
1999
English

GROMMET, PLASTIC, EDGING

MATERIAL: NYLON PER SPECIFICATION ASTM D4066, TYPE 1. POLYTETRAFLUOROETHYLENE (TFE) PER SPECIFICATION ASTM D1457. POLYFLUOROETHYLENEPROPYLENE (FEP) PER SPECIFICATION ASTM D2116.
DIN
DIN 125-1
1990
English

Product grade A washers with a hardness up to 250 HV designed for use with hexagon head bolts and nuts

This standard specifies requirements for product grade A washers with a hardness up to 250 HV, designed for use with bolts of properly class 8.8 or less. The preferred application of these wash [...]
ASTM
ASTM F788/F788M
1997
English

Standard Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series

1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs, including [...]
DIN
DIN 6900-3
1990
English

Screw and washer assemblies – Coarse threaded screws with captive curved spring lock washer

This standard specifies requirements for screw and washer assemblies consisting of an M2,5 to M12 screw with flat bearing face, assigned to a property class below 8.8, and a captive curved spri [...]
DIN
DIN 8195
1977
English

Design and selection of chain drives

1.1 This standard contains capacity rating charts and gives recommendations on the selection of chain drives, composed of roller chains and chain wheels conforming to DIN 8187 and DIN 8188, and [...]
BS EN
BS EN 10025-4
2004
English

Hot rolled products of structural steels — Part 4: Technical delivery conditions for thermomechanical rolled weldable fine grain structural steels

Part 4 of this document, in addition to Part 1, specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the thermomechanical rolled condition in [...]