DIN 436

Square washers for use in timber constructions

English 1990
0.000
DIN
Detailed Information

This standard specifies requirements for product grade C washers. The preferred application of these washers is in bolt/nut assemblies in timber constructions.

Download File
(Log in to download spec.)

Check out other specifications

DIN EN
DIN EN 10346
2009
English

Continuously hot-dip coated steel flat products – Technical delivery conditions – English version of DIN EN 10346:2009-07

This European Standard specifies requirements for continuously hot-dip coated products made of low carbon steels for cold forming, of steels for construction, of steels with high proof strength [...]
JIS
JIS B 0176-3
2002
English

Threading tools—Vocabulary Part 3 : Chaser

This part of JIS B 0176 specifies terms and definitions related to the chaser to be used mainly for metal workings in general.
JIS
JIS B 1122
1996
English

Cross recessed head tapping screws

This Japanese Industrial Standard specifies the steel cross recessed head tapping screws (hereafter, referred to as “steel tapping screws”) for general use.
JIS
JIS B 1112
1995
English

Cross-recessed head wood screws

This Japanese Industrial Standard specifies the cross-recessed head wood screws (Hereafter, referred to as "wood screws".) made of steel wire, stainless steel and brass for general use.
DIN EN
DIN EN 10083-1
1991
English

Quenched and tempered steels – Technical delivery conditions for special steels – English version of DIN EN 10083 Part 1

1.1 This European Standard gives the technical delivery requirements for — semi-finished products, hot formed, e.g. blooms, billets, slabs (see notes 3 and 4), — bars (see note 3), — rod, — w [...]
DIN
DIN 7995
1984
English

Cross recessed raised countersunk head wood screws

In previous editions of this standard, thread sizes 2,4 and 2,7 were included. In the March 1975 edition of this standard, these sizes were excluded from use in new designs. Because of the cont [...]
DIN
DIN 1816
1971
English

Round Nut with Set Pin Holes Inside – ISO Metric Fine Thread

Material (strength properties): at least 5 according to DIN 267 Part 4
ASTM
Abstract of ASTM B633
1998
English

ELECTRODEPOSITED COATINGS OF ZINC ON IRON AND STEEL

1.1 This specification covers requirements for electrodeposited zinc coatings applied to iron or steel articles to protect them from corrosion. It does not cover electrodeposited zinc coated st [...]
DIN
DIN 7983
1990
English

Cross recessed raised countersunk head tapping screws

DIN 7504 shall apply with regard to tapping screws with drilling tip (self-drilling screws). The DIN 4000 - 2 - 1 tabular layout of article characteristics shall apply for screws as covered in [...]