DIN 471

Circlips (retaining rings) for shafts – Normal type and heavy type

English 1981
0.000
DIN
Detailed Information

Circlips within the meaning of this standard are retaining rings for holding structural components (e.g. rolling bearings) on shafts. They are given an eccentric shape, are fitted with spring retention in grooves and are suitable for the transmission of axial forces.

Download File
(Log in to download spec.)

Check out other specifications

IFI
IFI-134
2008
English

MULTI-GRIP FLUSH BREAK PULL MANDREL SELF-PLUGGING BLIND RIVETS

This standard establishes the dimensional, mechanical and performance requirements of multi-grip flush break, positive lock pull mandrel self-plugging blind rivets suitable for use in joining t [...]
DIN
DIN 80705
1990
English

Thin nuts with coarse pitch and fine pitch thread and with small widths across flats

This standard specifies requirements for thin nuts with small widths across flats and ISO metric screw thread as specified in the DIN 13 series, assigned to product grades B and C. If, in speci [...]
ANSI ASME
ANSI/ASME B18.5.2.2M
1993
English

METRIC ROUND HEAD SQUARE NECK BOLTS

1.1 This standard covers the complete general and dimensional data for metric series round head square neck bolts recognized as American National Standard, and intended for general applications [...]
DIN
DIN 6887
1968
English

Stressed-type Fastenings with Taper Action – Taper Keys with Gib Head – Keyways – Dimensions and Application

So far no permissible variations have been laid down for the taper on the key and in the keyway. If special conditions make necessary the observance of certain permissible variations these must [...]
BS EN ISO
BS EN ISO 2320
2008
English

Prevailing torque type steel nuts — Mechanical and performance properties (ISO 2320:2008)

This International Standard specifies the mechanical and performance properties for prevailing torque type steel nuts when tested at an ambient temperature range of +10 °C to +35 °C. It include [...]
IFI
IFI-110
2008
English

GLOSSARY OF TERMS RELATING TO BLIND RIVETS

This glossary presents preferred nomenclature and definitions of terms relating to blind rivets. It is intended that this glossary serve as a guide to users and producers to assist them toward [...]
ISO
ISO 885
1976
English

General purpose bolts and screws – Metric series – Radii under the head

This International Standard specifies the sizes of the radii under the head of metric series general purpose bolts and screws.
DIN
DIN 6922
1983
English

Hexagon flange bolts with reduced shank

This standard specifies product grade A hexagon flange bolts with metric coarse screw thread or metric fine screw thread from 5 up to and including 20 mm nominal thread diameter. If, in special [...]
ASTM
Abstract of ASTM F880
2002
English

STAINLESS STEEL SOCKET SET SCREWS

1.1 This specification covers the requirements for austenitic grade stainless steel socket set screws (SSS). sizes 0.060 through 0.500 in. in two conditions, AF and CW.