DIN 526

Safety Cups for Cheese Head Screws according to DIN 84

English 1973
0.000
DIN
Detailed Information

Material: St 1303 according to DIN 1623 or St 3 according to DIN 1624 at manufacturer’s choice
Finish: without burr

Download File
(Log in to download spec.)

Check out other specifications

JIS
JIS B 1115
1996
English

Slotted head tapping screws

This Japanese Industrial Standard specifies the steel slotted head tapping screws (hereafter, referred to as “steel tapping screws”) for general use.
IFI
IFI-117
2008
English

PULL THROUGH MANDREL BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements for inch series pull through mandrel blind rivets suitable for use in engineering assemblies where load trans [...]
ISO
ISO 888
1976
English

Bolts, screws and studs – Nominal lengths, and thread lengths for general purpose bolts

This International Standard specifies nominal lengths for bolts, screws and studs, and thread lengths for general purpose bolts.
DIN
DIN 933
1987
English

M 1,6 to M 52 hexagon head screws threaded up to the head – Product grades A and B

This standard specifies requirements for M1,6 to M52 hexagon head screws threaded up to the head, assigned to product grade A, for sizes up to M24 and length not exceeding 10d or 150mm, and to [...]
NASM
NASM 35275
1999
English

SCREW, MACHINE-DRILLED FILLISTER HEAD, SLOTTED, CORROSION RESISTING STEEL, PASSIVATED, UNC-2A

DRILLED HOLE IS TO BE APPROXIMATELY AT RIGHT ANGLES TO THE SLOT AND MAY BE PERMITTED TO BREAK THROUGH THE BOTTOM OF THE SLOT. ALL SHARP EDGES SHALL BE REMOVED.
JIS
JIS B 0262
1989
English

Inspection method for taper screw gauges

This Japanese Industrial Standard specifies the inspection method of taper screw gauges for pipes specified in JIS B 0253 (hereafter referred to as the "taper screw gauges"). Furthermore, the [...]