DIN 546

Slotted round nuts

English 1986
0.000
DIN
Detailed Information

Slotted round nuts are parts generally made of steel, stainless steel or non-ferrous metals, which are designed to be used for various purposes, as for instance in electrical engineering.They can be tightened by means of a slotted screwdriver as specified in DIN 3115 Parts 1 and 2 and are intended to be used for locking components where no specific prestressing forces or a specific resistance to stripping are required.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 553
1986
English

Slotted set screws with cone point (modified version of ISO 7434, 1983 edition )

This standard specifies the characteristics of M 1 to M 12 slotted set screws with cone point, assigned to product grade A. Where, for special purposes, the screws are to meet requirements […]
DIN
DIN 7996
1986
English

Cross recessed pan head wood screws

As a departure from DIN 7996, March 1975 edition (which was withdrawn in December 1984), the present edition specifies a second type of cross recess, viz. cross recess type Z, also referred […]
DIN
DIN 4000-9
1986
English

Tabular layouts of article characteristics for bolts, pins, rivets, and keys

This standard specifies tabular layouts, in accordance with DIN 4000 Part 1, for standardized and non-standardized bolts, pins, rivets, and keys.
DIN
DIN 939
1995
English

Studs – with a length of engagement equal to about 1,25 d

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in cast iron. As specified in DIN 267-2, the stud end thread shall be produced to tole […]
DIN
DIN 940
1995
English

Studs – with a length of engagement equal to about 2,5 d

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in light metals of low strength. As specified in DIN 267-2, the stud end thread shall […]
DIN EN
DIN EN 28736
1992
English

Unhardened taper pins with internal thread (ISO 8736 : 1986) English version of DIN EN 28 736

This International Standard specifies the characteristics of unhardened taper pins with internal thread, and metric dimensions and nominal diameters, d1, from 6 to 50 mm inclusive.
ASTM
Abstract of ASTM F467
2001
English

NONFERROUS NUTS FOR GENERAL USE

1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general s […]
ASTM
Abstract of ASTM F1137
1993
English

PHOSPHATE/OIL AND PHOSPHATE/ORGANIC CORROSION PROTECTIVE COATINGS FOR FASTENERS

1.1 This specification covers the basic requirements for three grades of corrosion protective coatings for fasteners. Grade I consists of a zinc phosphate coating with a supplemental protec […]
DIN
DIN 1804
1971
English

Slotted Round Nut for Hook Spanner – ISO Metric Fine Thread

Material (strength properties): at least 5 according to DIN 267 Sheet 4 Type: w unhardened and unground h hardened to HRC 60 ± 2 with the exception of the thread, faces ground For hook wren […]