DIN 582

Lifting Eye Nuts

English 1971
0.000
DIN
Detailed Information

Lifting eye nuts must always be tightened so that they bear solidly on the surface they contact. Loads at right angles to the plane of the eye are prohibited.
When a specific position in relation to an axis, edge or the like is specified for the lifting eye nut when screwed on, shims should be used if necessary in order to rule out unacceptable loading.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 6880
1975
English

Bright steel for key bars – Dimensions, limit deviations, mass

This Standard applies to bright key steel in bars of square, rectangular or flat-rectangular cross-section in the nominal dimensions indicated in Tables 1 and 2 and in the steel specified in Se [...]
ASME
ASME B18.13
2008
English

SCREW AND WASHER ASSEMBLIES – SEMS

(a) This standard covers general and dimensional data pertinent to the various types of screw and captive washer assemblies, otherwise known as SEMS. The word SEMS is recognized in the United S [...]
ASTM
Abstract of ASTM F467
2001
English

NONFERROUS NUTS FOR GENERAL USE

1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general servi [...]
DIN EN
DIN EN 10083-2
2006
English

Steels for quenching and tempering – Part 2: Technical delivery conditions for non alloy steels – English version of DIN EN 10083-2:2006-10

This part of EN 10083, in addition to Part 1, specifies the technical delivery requirements for: — semi-finished products, hot formed, e.g. blooms, billets, slabs (see NOTES 2 and 3 in EN 10083 [...]
ASTM
ASTM A449
2010
English

HEX CAP SCREWS, BOLTS, AND STUDS, STEEL, HEAT TREATED, 120/105/90 KSI MINIMUM TENSILE STRENGTH, GENERAL USE

1.1 This specification covers quenched and tempered steel hex cap screws, bolts, and studs having a minimum tensile strength of 120 ksi for diameters 1.0 in. and smaller; 105 ksi for diameters [...]
DIN
DIN 6434
1984
English

Rivet sets

This standard specifies requirements and technical delivery conditions for rivet sets intended to be used with DIN 660, DIN 661, DIN 662 and DIN 674 rivets.
ASTM
ASTM F568M
1996
English

Standard Specification for Carbon and Alloy Steel Externally Threaded Metric Fasteners

1.1 This specification covers chemical and mechanical requirements for nine property classes of carbon and alloy steel externally threaded metric fasteners in nominal thread diameters M1.6 thro [...]
JIS
JIS B 1060
2003
English

Mechanical and performance requirements of case hardened and tempered metric thread rolling screws

This Standard specifies the requirements for case hardened and tempered metric thread rolling screws. Thread rolling screws according to this Standard produce female threads which fit general p [...]
ASME
Abstract ASME B1.15
1995
English

UNIFIED INCH SCREW THREADS (UNJ THREAD FORM)

This standard establishes the basic triangular profile for the UNJ thread form, provides a system of designations, lists the standard series of diameter-pitch combinations for diameters from 0. [...]