Check out other specifications
1991
English
Determination of coefficient of friction of bolt/nut assemblies under specified conditions
This standard specifies a tightening test for determining the coefficient of friction of bolt/nut assemblies under specified conditions. It is only applicable for comparison purposes, such as a [...]
1968
English
Stressed-type Fastenings with Taper Action – Taper Keys with Gib Head – Keyways – Dimensions and Application
So far no permissible variations have been laid down for the taper on the key and in the keyway. If special conditions make necessary the observance of certain permissible variations these must [...]
1995
English
Stainless steels – Part 3: Technical delivery conditions for semi-finished products, bars, rods and sections for general purposes
1.1 This part of EN 10088 specifies the technical delivery conditions for semi-finished products, hot or cold formed bars, rods and sections of standard grades and special grades of stainless s [...]
1992
English
ALLOY STEEL SOCKET BUTTON AND FLAT COUNTERSUNK HEAD CAP SCREWS [METRIC]
1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws M3 through M20 thread sizes havin [...]
1992
English
Hexagon thin nuts with metric fine pitch thread – Product grades A and B (ISO 8675 :1988) English version of DIN EN 28675
This International Standard gives specifications for hexagon thin nuts, with metric fine pitch thread, with nominal thread diameters d from 8 mm up to and including 64 mm, with product grade A [...]
1992
English
Half-length reverse taper grooved pins (ISO 8741 : 1986) English version of DIN EN 28 741
This International Standard specifies the characteristics of half-length reverse taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, w [...]