DIN 6880

Bright steel for key bars – Dimensions, limit deviations, mass

English 1975
0.000
DIN
Detailed Information

This Standard applies to bright key steel in bars of square, rectangular or flat-rectangular cross-section in the nominal dimensions indicated in Tables 1 and 2 and in the steel specified in Section 6.

This Standard does not apply to bright flat steel (see DIN 174) and bright square steel (see DIN 178).

Download File
(Log in to download spec.)

Check out other specifications

ASME
Abstract ASME B1.15
1995
English

UNIFIED INCH SCREW THREADS (UNJ THREAD FORM)

This standard establishes the basic triangular profile for the UNJ thread form, provides a system of designations, lists the standard series of diameter-pitch combinations for diameters from 0. [...]
DIN
DIN 1544
1975
English

Plat Steel Products – Cold Rolled Steel Strip – Dimensions, Permissible Variations on Dimensions and Form

1.1. This Standard applies to cold rolled flat products ≥ 0.10 ≤ 6 mm thick without surface coatings, and in particular to cold rolled strip in rolling widths ≤ 650 mm and bars cut from such st [...]
ANSI
ANSI B18.22M
1990
English

METRIC PLAIN WASHERS

This standard covers general specifications and dimensions for flat, round hole washers, both soft (as fabricated) and hardened, intended for use in general purpose applications. The inclusion [...]
DIN
DIN 918
1979
English

Fasteners – Terminology – Spelling of terms – Abbreviations

This standard applies to fasteners as described in clause 2 and specifies terms for them, terms for the most important characteristics of the parts and their abbreviations. When specifying desc [...]
ISO
ISO 4757
1983
English

Cross recesses for screws

This International Standard defines two types of cross recesses for screws: - recess type H; - recess type Z. Included in this International Standard is a method of penetration gauging for both types.
DIN
DIN 561
1995
English

Hexagon set screws with small hexagon and full dog point

This standard specifies dimensions and technical delivery conditions for coarse and fine pitch thread M6 to M56 hexagon set screws with small hexagon and full dog point, assigned to product gra [...]
ASTM
Abstract of ASTM A325
2002
English

STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes [...]
DIN
DIN 525
1986
English

Weld studs

Weld studs are fasteners which are primarily selected because of their weldability. When determining what loadbearing capacity weld studs are to have, account shall be taken of their inherent s [...]
DIN
DIN 427
1986
English

Slotted headless screws with chamfered end

This standard specifies the characteristics of M 1 to M 20 slotted headless screws with chamfered end. Where, for special applications, the screws are to meet requirements differing from those [...]