DIN 6881

Taper Key Torque Transmission – Saddle Keys – Dimensions and Application

English 1956
0.000
DIN
Detailed Information

No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.

Download File
(Log in to download spec.)

Check out other specifications

MIL
MIL-DTL-25027H
1997
English

NUT, SELF-LOCKING, 250° F, 450° F, AND 800° F

This specification covers self-locking nuts for use in temperatures of 250° F, 450° F, and 800° F (see 6.1).
BS EN
BS EN 12163
2011
English

Copper and copper alloys — Rod for general purposes

This European Standard specifies the composition, property requirements and dimensional tolerances for copper alloy rod in the shape of circles, squares, hexagons or octagons, finally produced by drawing or extruding intended for general purposes. The sampling procedures and the methods […]
DIN EN
DIN EN 10269 Berichtigung 2
2007
German

Stähle und Nickellegierungen für Befestigungselemente für den Einsatz bei erhöhten und/oder tiefen Temperaturen; Deutsche Fassung EN 10269:1999 + A1:2006, Berichtigungen zu DIN EN 10269:2006-07

Es wird empfohlen, auf der betroffenen Norm einen Hinweis auf diese Berichtigung zu machen.
DIN
DIN 522
1990
English

Metal washers – Technical delivery conditions

This standard specifies requirements for metal washers manufactured by stamping (punching) which thus exhibit inside and outside rollover and fracture (cf. DIN6930 Part 2 and DIN6932). It does not cover washers manufactured by machining (e.g. by drilling or turning). This standard specif […]
JIS
JIS B 1107
2004
English

Hexalobular socket head screws

This Standard specifies the characteristics of hexalobular socket head screws in product grades A and with nominal thread sizes from M2 up to and including M10. If other specifications than those listed in this Standard are required, they should be selected from existing JIS standards, f […]
JIS
JIS B 1083
1990
English

General rules for tightening of threaded fasteners

This Japanese Industrial Standard specifies general matters relating to significance of tightening by combination of bolt and nut, basis of tightening and representative control method. Further, this Standard is applicable to tightening by threaded fasteners other than bolt and nut, and […]