DIN 6884

Taper Key Torque Transmission – Gib-head Parallel Keys – Dimensions and Application

English 1956
0.000
DIN
Detailed Information

No figures tor permissible variations of tapers on keys and in hub keyways have so tar been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.

Download File
(Log in to download spec.)

Check out other specifications

JIS
JIS B 0209-4
2001
English

ISO general purpose metric screw threads — Tolerances — Part 4: Limits of sizes for hot -dip galvanized external screw threads to mate with internal screw threads tapped with tolerance position H or G after galvanizing

This Standard specifies deviations and limits of sizes for pitch and crest diameters for ISO general purpose metric external screw threads conforming to JIS B 0205-3 having a basic profile according to JIS B 0205-1. External screw threads according to this Standard are intended to mate w […]
DIN
DIN 6928
1990
English

Hexagon washer head tapping screws

Hexagon washer head tapping screws are made with a DIN 7970 tapping screw thread that complies with the specifications of International Standard ISO 1478 :1983). It should be noted that, since 1983, tapping screw threads have been identified with the symbol ST (denoting ‘spaced thread') w […]
ASTM
ASTM F2280
2008
English

“TWIST OFF” TYPE TENSION CONTROL STRUCTURAL BOLT/NUT/WASHER ASSEMBLIES, STEEL, HEAT TREATED, 150 KSI MINUMUM TENSILE STRENGTH

1.1 This specification covers two types of heat treated, steel, tension control bolt-nut-washer assemblies, also referred to as "sets," having a tensile strength of 150 to 173 ksi. These assemblies are capable of developing a minimum predetermined tension when installed by applying torque […]
IFI
IFI-155
2005
English

TEST PROCEDURE FOR THE PERFORMANCE OF NONMETALLIC RESISTANT ELEMENT PREVAILING-TORQUE NUTS-INCH SERIES

This standard establishes a test procedure for nonmetallic resistant element prevailing-torque nuts having coarse threads, to determine their conformance with specified prevailing-torque requirements in nominal sizes #10 thru 1 in. intended for application temperatures of - 49°F to 250°F. […]
ASTM
Abstract of ASTM F788/F788M
2008
English

SURFACE DISCONTINUITIES OF BOLTS, SCREWS, AND STUDS

This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolt, screws, and studs, including heat-treated machine screws, tapping screws, and sems (the washers of screw-washer assemblies are exc […]
ASTM
Abstract of ASTM F901
2001
English

ALUMINUM TRANSMISSION TOWER BOLTS AND NUTS

1.1 This specification covers aluminum structural bolts and nuts for use in the construction of aluminum transmission towers, substations, and similar aluminum structures. 1.2 Diameters of bolts and nuts furnished to this specification are 5/8, 3/4, and 7/8 in. 1.3 The values stated in in […]