DIN 6917

Square taper washers for high-strength structural bolting of steel I sections

English 1989
0.000
DIN
Detailed Information

Washers as specified in this standard are intended for use in GV and SL structural bolting of steel I sections in accordance with DIN 18 800 Part 1, together with DIN 6914 screws and DIN 6915 nuts.

Download File
(Log in to download spec.)

Check out other specifications

IFI
IFI-125
2007
English

TEST PROCEDURE FOR THE PERFORMANCE OF ADHESIVE COATED PREVAILING-TORQUE SCREWS

This standard establishes a conformance test procedure for the performance of adhesive coated prevailing-torque screws, in nominal screw sizes No. 4 thru 3/4 in. Torque values given in this st [...]
DIN
DIN 6881
1956
English

Taper Key Torque Transmission – Saddle Keys – Dimensions and Application

No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these mu [...]
DIN
DIN 797
1970
English

Special Foundation Bolts

Strength category (material): 3.6 according to DIN 267 Part 3 Other strength categories or materials by agreement
DIN
DIN 7965
1965
English

Screwed Inserts (Screw Plugs)

These screwed inserts are intended primarily for screwing into wood or wood-like materials.
IFI
IFI-560
2007
English

TEST PROCEDURE FOR THE PERFORMANCE OF NUTS WITH PRE-APPLIED ADHESIVE COATED THREADS- METRIC SERIES

This standard establishes a conformance test procedure for the performance of pre-applied adhesive coatings applied to metric series nuts, in nominal sizes M5 thru M20 intended for application [...]
DIN EN
DIN EN 28739
1992
English

Full-length parallel grooved pins, with pilot (ISO 8739 : 1986) English version of DIN EN 28 739

This International Standard specifies the characteristics of full-length parallel grooved pins with pilot which have three equally spaced grooves impressed longitudinally on their exterior surf [...]
DIN
DIN 918 Supplement 3
1995
English

Synopsis of European Standards for fasteners

This Supplement reflects the most recent state of European standardization for fasteners by including: a) a list of DIN EN Standards classified by subject, and the correlated DIN Standards and [...]
ASME
ASME B1.3M
1992
English

SCREW THREAD GAGING SYSTEMS FOR DIMENSIONAL ACCEPTABILITY OF METRIC SCREW THREADS

(a) This standard presents screw thread gaging systems suitable for determining the acceptability of UN, UNR. UNJ, M. and MJ screw threads on externally and internally threaded products. It est [...]
ISO
ISO 965-1
1980
English

ISO general purpose metric screw threads – Tolerances – Part 1 : Principles and basic data

This International Standard specifies a tolerance system for screw threads conforming to ISO 261, ISO general purpose metric screw threads - General plan. The tolerance system refers to the bas [...]