DIN 6930-2

Steel stampings – General tolerances

English 1989
0.000
DIN
Detailed Information

This standard is intended to simplify drawings. It specifies general tolerances on linear and angular dimensions and on coaxiality and symmetry in four accuracy grades comprising f (fine), m(medium), g (coarse) and sg (very coarse). When selecting a defined accuracy grade, the respective workshop accuracy is to be taken into account.

If smaller tolerances are required or if larger tolerances are permitted and more economical, these shall be indicated adjacent to the relevant basic size.

Download File
(Log in to download spec.)

Check out other specifications

DIN EN
DIN EN 1661
1998
English

Hexagon nuts with flange (ISO/DIS 4161 : 1996, modified) English version of DIN EN 1661

This European Standard specifies the characteristics of hexagon nuts with flange, with threads from M5 to M20 inclusive, of product grade A for threads up to and including M 16 and product […]
ISO
ISO 7415
1984
English

Plain washers for high-strength structural bolting, hardened and tempered

This International Standard specifies those hardened and tempered circular washers intended for assembly with large series hexagon high-strength structural bolts and nuts of diameters from […]
DIN
DIN 551
1972
English

Slotted Set Screws with Chamfered Ends

Compared with the April 1956 issue, the following amendments and additions should be noted: a) In agreement with the international selection of threads for screws and bolts, the sizes M 1.6 […]
DIN
DIN 937
1983
English

Hexagon thin castle nuts (previous design)

This standard gives specifications for hexagon thin castle nuts with metric threads ranging from 6 to 52 mm nominal thread diameter, assigned to product grades A (up to and including 16 mm […]
ISO
ISO 4042
2018
English

Fasteners — Electroplated coating systems

This document specifies requirements for electroplated coatings and coating systems on steel fasteners. The requirements related to dimensional properties also apply to fasteners made of co […]
DIN
DIN 7982
1984
English

Cross recessed countersunk head tapping screws

DIN 6901 shall apply for the designation of tapping screws with captive washer components (tapping screw assemblies). DIN 4000 - 2 - 1 tabular layout of article characteristics shall apply […]
DIN
DIN 1587
1987
English

Hexagon domed cap nuts

This standard specifies requirements for M 4 to M 24 coarse and fine pitch thread hexagon domed cap nuts assigned to product grade A or B. If, in special cases, nuts are to comply with spe […]
DIN EN
DIN EN 24014
1992
English

Hexagon head bolts – Product grades A and B (ISO 4014 : 1988) English version of DIN EN 24014

This International Standard gives specifications for hexagon head bolts with threads from M1,6 up to and including M64, of product grade A for threads M1,6 to M24 and nominal lengths up to […]
DIN
DIN 431
1982
English

Pipe nuts with thread in accordance with DIN ISO 228 Part 1

This standard gives specifications for (hexagon and octagon) pipe nuts with thread in accordance with DIN ISO 228 Part 1 of nominal sizes G 1/8 up to and including G 6, assigned to product […]