Check out other specifications
1995
English
Cross recessed head thread cutting screws – Dimensions, requirements and testing
This standard specifies dimensions, requirements and test methods for heat-treated cross recessed head thread cutting screws with an ISO metric thread as specified in DIN 13-12, with cutting flutes extending from the point of the screw to its head, and designed to cut their mating thread […]
2014
English
Specification for Electroplated Zinc Coatings on Fasteners
JDM F15 specifies requirements for electroplated zinc coatings for fasteners made of steel. JDM F15 applies primarily to electroplated coatings on threaded fasteners, non-threaded fasteners, and fastener accessories such as pins and washers. JDM F15 may also be applied to other threaded p […]
1990
English
Screw and washer assemblies – Coarse threaded screws with captive plain washer
This standard specifies requirements for screw and washer assemblies consisting of an M 2,5 to M12 screw with flat bearing face, assigned to property class 10.9 or less, and a captive plain washer. Socket or cross recessed head screws the critical cross section of which is not located in […]
1991
English
STAINLESS STEEL SOCKET HEAD CAP SCREWS [METRIC]
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric socket head cap screws (SHCS) with nominal thread M1.6 through M36 and intended for use in applications requiring general corrosion resistance.
1989
English
Square taper washers for high-strength structural bolting of steel I sections
Washers as specified in this standard are intended for use in GV and SL structural bolting of steel I sections in accordance with DIN 18 800 Part 1, together with DIN 6914 screws and DIN 6915 nuts.