Check out other specifications
2010
English
CARBON AND ALLOY STEEL NUTS FOR BOLTS FOR HIGH PRESSURE OR HIGH TEMPERATURE SERVICE, OR BOTH
1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1/4 through 4 in. nominal. It also covers austenitic stainless steel nuts in the size range 1/4 in. nominal and above. These nuts are intended for high-pressure or high-tempera […]
2000
English
Plain washers – Small series – Product grade A
This International Standard specifies the characteristics of small-series, product-grade-A plain washers in the 200 HV and 300 HV hardness classes and of nominal sizes (nominal thread diameters) ranging from 1,6 mm to 36 mm inclusive.
1992
English
Hardened parallel pins with internal thread (ISO 8735 : 1987) English version of DIN EN 28 735
This International Standard specifies the characteristics of through hardened and case hardened parallel pins with internal thread, metric dimensions and nominal diameters, d1, from 6 to 50 mm inclusive.
2007
English
ANCHOR BOLTS, STEEL, 36, 55, AND 105-KSI YIELD STRENGTH
1.1 This specification covers straight and bent, headed and headless, carbon, carbon boron, alloy, or high-strength low-alloy steel anchor bolts (also known as anchor rods). The anchor bolts are furnished in three strength grades, two thread classes, and in the sizes specified in Section […]
1967
English
Stressed-type Fastenings with Taper Action – Taper Keys – Keyways – Dimensions and Application
For the time being no permissible variations have been laid down for the taper on the key and in the hub keyway. If special conditions make necessary the observance of certain permissible variations these must be agreed at the time of ordering. The dimension h is the maximum height of the […]
1998
English
Technical drawings — Screw threads and threaded parts — Part 1 : General conventions
This part of JIS B 0002 specifies methods for representing screw threads and threaded parts on technical drawings.