The following amendments have been made in comparison with the March 1975 edition. a) Nominal lengths 90 mm and 100 mm have been deleted in order to bring this standard into line with the other standards on wood screws. b) Type g has been replaced by product grade C. c) The content of the […]

Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data. Technical conditions of delivery and material according to DIN 267 Sheet 12 (at present circulating as draft).

This glossary presents preferred nomenclature and definitions of terms relating to blind rivets. It is intended that this glossary serve as a guide to users and producers to assist them toward the use of a single system of terminology for the characteristics and properties of blind rivet […]

This standard specifies requirements for M 4 to M 72 coarse and fine pitch thread hexagon cap nuts assigned to product grade A.

This International Standard gives specifications for hexagon flange bolts, small series, with threads from M5 up to and including M16 and property classes 8.8 to 10.9 and A2·70.

The dimensions of turnbuckle nuts up to M 48 have been related to tubes according to DIN 2448 and brought into line with DIN 82004.