DIN 78

Bolt end protrusions

English 2001
0.000
DIN
Detailed Information

This standard specifies minimum bolt end protrusions for general purpose assemblies of bolts, screws, studs and similar fasteners with ISO metric screw thread (coarse pitch thread) as in DIN 13-1 and DIN ISO 261, and hexagon nuts.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM F844
2000
English

UNHARDENED STEEL WASHERS

1.1 This specification covers round and miscellaneous shape steel plain (flat) washers furnished in an unhardened condition. 1.2 The washers are intended for general use bolt, nut, and stud app [...]
DIN
DIN 918 Supplement 3
2001
English

Overview of European Standards for fasteners

This Supplement reflects the most recent state of European standardization of fasteners by including: a) a list of DIN EN Standards classified by subject, and the correlated DIN Standards and D [...]
DIN
DIN 562
2000
English

Square thin nuts Product grade B

This standard specifies dimensions and technical delivery conditions for sizes M1,6 to M10 square thin nuts of product grade B.
ASME
ASME B18.2.1
2010
English

SQUARE, HEX, HEAVY HEX, AND ASKEW HEAD BOLTS AND HEX, HEAVY HEX, HEX FLANGE, LOBED HEAD, AND LAG SCREWS (INCH SERIES)

1.1.1 This Standard covers the dimensional requirements for nine product types of inch series bolts and screws recognized as American National Standard. Also included are appendices covering ga [...]
5.01
DIN
DIN 74361-2
1982
English

Disc wheels for motor vehicles and trailers – Fasteners for stud centring

This standard specifies requirements for fasteners for stud-centred disc wheels on motor vehicles and trailers. Any necessary draft on the hexagon shall be within the tolerance on the width acr [...]
ISO
ISO 3800-1
1977
English

Threaded fasteners – Axial load fatigue testing – Part 1 : Test methods

This International Standard specifies the conditions for carrying out axial load fatigue tests on threaded fasteners.
ASTM
ASTM B695
2009
English

COATINGS OF ZINC MECHANICALLY DEPOSITED ON IRON AND STEEL

This specification covers the requirements for a coating of zinc mechanically deposited on iron and steel basis metals. The coating is provided in several thicknesses up to and including 107 μm [...]
DIN
DIN 6303
1986
English

Knurled nuts

The following amendments have been made in comparison with the January 1971 edition a) The content of the standard has been editorially revised and aligned with the basic standards concerned b) [...]
ASTM
Abstract of ASTM A490M
1993
English

HIGH-STRENGTH STEEL BOLTS, CLASSES 10.9 AND 10.9.3, FOR STRUCTURAL STEEL JOINTS [METRIC]

1.1 This specification covers the chemical and mechanical requirements of quenched and tempered steel bolts, in nominal thread diameters M16 to M36, inclusive. These bolts are intended for use [...]