DIN 7969

Slotted countersunk head screws for structural steel bolting for supply with or without nut

English 1989
0.000
DIN
Detailed Information

This standard specifies requirements for M10 to M24 slotted countersunk head screws assigned to product grade C for use in structural steel bolting.

Download File
(Log in to download spec.)

Check out other specifications

JIS
JIS B 1124
2003
English

Drilling screws with tapping screw thread

This Standard is the Japanese Industrial Standard prepared based on first editions of ISO 15480 Hexagon washer head drilling screws with tapping screw thread, ISO 15481 Cross recessed pan head [...]
DIN
DIN 961
1990
English

M8 x 1 to M52 x 3 hexagon head bolts with fine pitch thread – Product grades A and B

This standard specifies requirements for M8 to M52 hexagon head bolts threaded up to the head. with metric fine pitch thread, assigned to product grade A for sizes up to M24 and lengths not exc [...]
ASTM
ASTM F2280
2008
English

“TWIST OFF” TYPE TENSION CONTROL STRUCTURAL BOLT/NUT/WASHER ASSEMBLIES, STEEL, HEAT TREATED, 150 KSI MINUMUM TENSILE STRENGTH

1.1 This specification covers two types of heat treated, steel, tension control bolt-nut-washer assemblies, also referred to as "sets," having a tensile strength of 150 to 173 ksi. These assemb [...]
JIS
JIS B 0205-2
2001
English

ISO general purpose metric screw threads — Part 2: General plan

This Standard specifies ISO general purpose metric screw threads (M) having basic profile according to JIS B 0205-1. Basic dimensions are given in JIS B 0205- 4. For tolerances see JIS B 0209-1.
ASTM
ASTM A574
1998
English

Standard Specification for Alloy Steel Socket-Head Cap Screws

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required. NOTE 1-A co [...]
DIN
DIN 464
1986
English

Knurled thumb screws

The following amendments have been made in comparison with the December 1970 edition of the present standard and the December 1970 edition of DIN 465. a) DIN 464 and DIN 465 have been combined [...]
DIN EN
DIN EN 20898-2
1994
English

Mechanical properties of fasteners – Nuts with coarse pitch thread and specified proof load values (ISO 898-2 : 1992) English version of DIN EN 20898 Part 2

This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lower te [...]
DIN
DIN 6926
1983
English

Prevailing torque type hexagon nuts with flange and with non-metallic insert

This standard gives specifications for prevailing torque type hexagon nuts with flange and with non-metallic insert, with metric thread with diameters from 5 to 20 mm, assigned to product grade [...]
ASME
ASME B1.20.5
2004
English

GAGING FOR DRYSEAL PIPE THREADS (INCH)

The scope of this Standard is to provide information regarding practical dryseal thread inspection methods and commonly used gages for production evaluation purposes. All dimensions are in inch [...]