DIN 7973
Raised Countersunk (Oval) Head Tapping Screws with Slot
English
1970
0.000
Detailed Information
Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data.
Technical conditions of delivery and material according to DIN 267 Sheet 12 (at present circulating as draft).
Download File
(Log in to download spec.)
Check out other specifications
2015
English
Standard Specification for Electrodeposited Coatings on Mechanical Fasteners, Inch and Metric
1.1 This specification covers application, performance and dimensional requirements for electrodeposited coatings on threaded fasteners with unified inch and metric screw threads, but it ma […]
5.01
1999
English
METRIC 12-SPLlNE FLANGE SCREWS
1.1 This standard covers the complete general and dimensional data for metric 12-spline flange screws recognized as American National Standard. 1.2 The inclusion of dimensional data in this […]
1992
English
Half-length taper grooved pins (ISO 8745 : 1986) English version of DIN EN 28 745
This International Standard specifies the characteristics of half-length taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with […]
1993
English
Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural Steel Joints [Metric]
1.1 This specification covers the chemical and mechanical requirements of quenched and tempered steel bolts, in nominal thread diameters M16 to M36, inch. These bolts are intended for use i […]
2015
English
Specification for Non-Electrolytically Applied Zinc Flake Coatings
1.1 JDM F13 specifies requirements for nine grades of corrosion resistant non-electrolytically applied zinc flake coatings on ferrous parts, with three levels of corrosion resistance, and t […]