DIN 7980
Federringe für Zylindcrschrauhcn
German
1972
0.000
Detailed Information
Die Oberfläche der Federringe muß glatt und frei von Zunder und Grat sein. Die Federringe müssen ohne Knicke gewunden und ihre äußeren Kanten scharfkantig bis leicht gerundet sein.
Download File
(Log in to download spec.)
Check out other specifications
2000
English
Hexagon weld nuts
This standard specifies requirements for sizes M3 to M16 coarse and fine pitch thread hexagon weld nuts of product grade A, for use with bolts of property classes below 8.8 as specified in DIN EN ISO 898-1. Hexagon weld nuts with flange are specified in DIN 977.
1987
English
Stress area and bearing area for threaded fasteners
This Japanese Industrial Standard specifies the stress area of metric screw thread and the area of the part where a load due to the contact of the bearing surface of threaded fastener and the other side is added, hereinafter referred to as the ”load area”. Furthermore, the method to obta […]
1967
English
Stressed-type Fastenings with Taper Action – Taper Keys – Keyways – Dimensions and Application
For the time being no permissible variations have been laid down for the taper on the key and in the hub keyway. If special conditions make necessary the observance of certain permissible variations these must be agreed at the time of ordering. The dimension h is the maximum height of the […]
2010
English
Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes – Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)
This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit devia […]
1997
English
COMPRESSIBLE-WASHER-TYPE DIRECT TENSION INDICATORS FOR USE WITH STRUCTURAL FASTENERS [METRIC]
1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt. 1.2 Two types of direct tension indicators in nominal diameter sizes M16 through M36 are c […]