DIN 7982

Cross recessed countersunk head tapping screws

English 1984
0.000
DIN
Detailed Information

DIN 6901 shall apply for the designation of tapping screws with captive washer components (tapping screw assemblies).
DIN 4000 – 2 – 1 tabular layout of article characteristics shall apply for screws in accordance with this standard.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 267-15
1983
English

Fasteners – Technical delivery conditions – Prevailing torque type nuts

The property classes, mechanical and performance properties and the methods of test listed in this standard apply to prevailing torque type nuts - with nominal thread diameters from 3 to 39 […]
ISO
ISO 1481
1983
English

Slotted pan head tapping screws

This International Standard specifies the characteristics of slotted pan head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.
DIN
DIN 6900-1
1990
English

Screw and washer assemblies – Coarse threaded screws with captive plain washer

This standard specifies requirements for screw and washer assemblies consisting of an M 2,5 to M12 screw with flat bearing face, assigned to property class 10.9 or less, and a captive plain […]
DIN
DIN 96
1986
English

Slotted round head wood screws

The following amendments have been made in comparison with the March 1975 edition. a) Nominal lengths 90 mm and 100 mm have been deleted in order to bring this standard into line with the o […]
DIN
DIN 50021
1988
English

Salt spray testing

This standard specifies the requirements which corrosion testing apparatuses and corrosive agents must meet in salt spray testing, the aim being to enable identical conditions to be reprodu […]
ISO
ISO 7378
1983
English

Fasteners – Bolts, screws and studs – Split pin holes and wire holes

This International Standard lays down the dimensions and position of split pin holes and wire holes for bolts, screws and studs, recommended for use unless otherwise specified in the approp […]
JIS
JIS B 1084
1990
English

Method of tightening test for threaded fasteners

This Japanese Industrial Standard specifies the method of test for obtaining characteristic value for tightening (hereafter referred to as "tightening characteristic value") by combination […]
DIN
DIN 6928
1990
English

Hexagon washer head tapping screws

Hexagon washer head tapping screws are made with a DIN 7970 tapping screw thread that complies with the specifications of International Standard ISO 1478 :1983). It should be noted that, si […]
DIN
DIN 961
1970
German

Sechskantschrauben- Gewinde annähernd bis Kopf – Metrisches Feingewinde – Ausführung m und mg

Üblicherweise werden diese Schrauben in den durch Gewichtsangabe gekennzeichneten Größen hergestellt. Technische Lieferbedingungen nach DIN 267